This is part of main ppt which will be opening from main ppt, it shows the progress of the project i am sure you will love this ppt You haven't seen this type of ppt this is by Mohan K M Ganesh C Yerriswamy A from PESIT Bangalore

1.  Design and programing of Relay Menu
 Interfacing LCD And Keyboard
 Design and Simulation of ZCD
 Design and Simulation of Measurement of Voltage Magnitude
8
80
100
100
7
40
90
100
0
0
35
85
5
40
75
95
27TH JAN 15TH FEB 1ST MAR 15TH MAR
PROJECT PROGRESS
PF V and I MHO Total

2. • Interfacing of LCD.
• Interfacing of Keyboard.
• ON/OFF Control.
• Reset.
• Menu.
• UP/DOWN/LEFT/RIGHT for navigation.
• Menu Consist of
• MTA Setting.
• Zone 1, Zone 2, Zone 3 impedance setting.
4/14/2014Electrical Department PES University

3. • Zero crossing detector(ZCD) is a voltage comparator that switches the output between
+Vsat and –Vsat when the input crosses zero reference voltage.
• Working of ZCD can be easily understood if you know the working of a basic op amp
comparator.
• In ZCD, we are setting one of the inputs as zero i.e. zero reference voltage.
• The output is driven into –Vsat when the input signal passes through zero to positive
direction.
• Conversely, when input signal passes through zero to negative direction, the output switches
to +Vsat.
4/14/2014Electrical Department PES University

4. 4/14/2014Electrical Department PES University
Multisim 13 VBB StudioProteus 8

5. 4/14/2014Electrical Department PES University

6. 4/14/2014Electrical Department PES University

7. 4/14/2014Electrical Department PES University

8. • Output wave from ZCD for Current input is square wave
with 50Hz frequency
• Output wave from ZCD for Voltage input is square
wave with 50Hz frequency
• Output magnitude of ZCD is equal to VCC
(3.56v, 5v, 12v)
4/14/2014Electrical Department PES University

9. • Current sensor is used to get corresponding voltage output and wave.
• From the output wave we will get current zero crossing and magnitude.
4/14/2014Electrical Department PES University

10. • High voltage is converted into low voltage by step down transformer.
• Analog voltage converted into Digital by ADC.
• Voltage magnitude is found by sampled digital value.
4/14/2014Electrical Department PES University

11. • From the ZCD we will get square wave for current and voltage zero crossing.
• The time gap between this 2 output wave of ZCD is found.
• From the time interval Power factor is calculated.
4/14/2014Electrical Department PES University