This document summarizes research on modeling vehicular exhaust emissions and methods for controlling emissions. It discusses the health and environmental impacts of emissions such as carbon monoxide, nitrogen oxides, and particulate matter. Methods for estimating emissions include software models like MOBILE-6 and COPERT 4, which take parameters like vehicle type and speed to calculate emission rates. The document also reviews technologies for reducing emissions, such as three-way catalytic converters. Standards for air pollutants in India are outlined and motivation for studying emission control is discussed.
National Air Quality Strategy: IAQM Committee’s View by Dr Claire HolmanIES / IAQM
Dr Claire Holman, Brook Cottage Consultants/University College London, Chair, Institute of Air Quality Management
IAQM Discussion Meeting: London 6 January 2018
Clean Air Strategy: Reducing Emissions of Air Pollution by Rebecca DangerfieldIES / IAQM
Rebecca Dangerfield
Joint Head of Local Air Quality with Susie Willows | Air Quality and Industrial Emissions | Environmental Quality Directorate | Department for Environment, Food and Rural Affairs
IAQM Discussion Meeting: London 6 January 2018
Credits of the presentation are to the Philippine Department of Environment and Natural Resources.
This presentation was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
In Chhattisgarh, Raipur-Durg-Bhilai (RDB) tri-city area hosts the state's new administrative capital, interconnected by an expressway forming the industrial corridor and is one of the largest steel manufacturing hubs in India. Between 1998 and 2016, the satellite and global model data-derived concentrations show a 50% increase in the overall PM2.5 pollution in the region.
Credits of the presentation are to the Philippine Department of Environment and Natural Resources.
This presentation was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
Credits of the paper are to the Philippine Department of Environment and Natural Resources.
This paper was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
Analysis of Emission from Petrol Vehicles in the Koforidua Municipality, GhanaIJERA Editor
Koforidua has seen its fair share in the increase in the number of cars on its roads over the past decade. This has resulted in progressive increase in traffic congestion on the roads and could lead to deterioration in the air quality. Exhaust gas emissions from a total of 104 vehicles were tested with an exhaust gas analyzer. Hydrocarbons (HC), Carbon dioxide (CO2) and Carbon monoxide (CO) were measured and compared with EU standards for gasoline vehicles and Auto Data Technical information. A series of algorithms developed using Microsoft Excel Spread Sheet were used to analyze the data collected. Out of the total number of cars tested, 74 and 80 cars passed the HC and CO tests respectively. 10 cars out of the total were rated as good under CO2 test. In total, 69.5% of the cars tested passed the various tests conducted and about 73 cars representing 70.2% of the cars tested were over 10 years and the emission standards for those years were flexible.
National Air Quality Strategy: IAQM Committee’s View by Dr Claire HolmanIES / IAQM
Dr Claire Holman, Brook Cottage Consultants/University College London, Chair, Institute of Air Quality Management
IAQM Discussion Meeting: London 6 January 2018
Clean Air Strategy: Reducing Emissions of Air Pollution by Rebecca DangerfieldIES / IAQM
Rebecca Dangerfield
Joint Head of Local Air Quality with Susie Willows | Air Quality and Industrial Emissions | Environmental Quality Directorate | Department for Environment, Food and Rural Affairs
IAQM Discussion Meeting: London 6 January 2018
Credits of the presentation are to the Philippine Department of Environment and Natural Resources.
This presentation was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
In Chhattisgarh, Raipur-Durg-Bhilai (RDB) tri-city area hosts the state's new administrative capital, interconnected by an expressway forming the industrial corridor and is one of the largest steel manufacturing hubs in India. Between 1998 and 2016, the satellite and global model data-derived concentrations show a 50% increase in the overall PM2.5 pollution in the region.
Credits of the presentation are to the Philippine Department of Environment and Natural Resources.
This presentation was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
Credits of the paper are to the Philippine Department of Environment and Natural Resources.
This paper was included in the event kit of Green Bloggers Forum, held 7 June 2016 at the Cocoon Boutique Hotel, QC, Philippines. The DENR authorized all bloggers and participants to promote the information and materials during the event.
Analysis of Emission from Petrol Vehicles in the Koforidua Municipality, GhanaIJERA Editor
Koforidua has seen its fair share in the increase in the number of cars on its roads over the past decade. This has resulted in progressive increase in traffic congestion on the roads and could lead to deterioration in the air quality. Exhaust gas emissions from a total of 104 vehicles were tested with an exhaust gas analyzer. Hydrocarbons (HC), Carbon dioxide (CO2) and Carbon monoxide (CO) were measured and compared with EU standards for gasoline vehicles and Auto Data Technical information. A series of algorithms developed using Microsoft Excel Spread Sheet were used to analyze the data collected. Out of the total number of cars tested, 74 and 80 cars passed the HC and CO tests respectively. 10 cars out of the total were rated as good under CO2 test. In total, 69.5% of the cars tested passed the various tests conducted and about 73 cars representing 70.2% of the cars tested were over 10 years and the emission standards for those years were flexible.
Industrial Training at Shahjalal Fertilizer Company Limited (SFCL)MdTanvirMahtab2
This presentation is about the working procedure of Shahjalal Fertilizer Company Limited (SFCL). A Govt. owned Company of Bangladesh Chemical Industries Corporation under Ministry of Industries.
Event Management System Vb Net Project Report.pdfKamal Acharya
In present era, the scopes of information technology growing with a very fast .We do not see any are untouched from this industry. The scope of information technology has become wider includes: Business and industry. Household Business, Communication, Education, Entertainment, Science, Medicine, Engineering, Distance Learning, Weather Forecasting. Carrier Searching and so on.
My project named “Event Management System” is software that store and maintained all events coordinated in college. It also helpful to print related reports. My project will help to record the events coordinated by faculties with their Name, Event subject, date & details in an efficient & effective ways.
In my system we have to make a system by which a user can record all events coordinated by a particular faculty. In our proposed system some more featured are added which differs it from the existing system such as security.
Immunizing Image Classifiers Against Localized Adversary Attacksgerogepatton
This paper addresses the vulnerability of deep learning models, particularly convolutional neural networks
(CNN)s, to adversarial attacks and presents a proactive training technique designed to counter them. We
introduce a novel volumization algorithm, which transforms 2D images into 3D volumetric representations.
When combined with 3D convolution and deep curriculum learning optimization (CLO), itsignificantly improves
the immunity of models against localized universal attacks by up to 40%. We evaluate our proposed approach
using contemporary CNN architectures and the modified Canadian Institute for Advanced Research (CIFAR-10
and CIFAR-100) and ImageNet Large Scale Visual Recognition Challenge (ILSVRC12) datasets, showcasing
accuracy improvements over previous techniques. The results indicate that the combination of the volumetric
input and curriculum learning holds significant promise for mitigating adversarial attacks without necessitating
adversary training.
CFD Simulation of By-pass Flow in a HRSG module by R&R Consult.pptxR&R Consult
CFD analysis is incredibly effective at solving mysteries and improving the performance of complex systems!
Here's a great example: At a large natural gas-fired power plant, where they use waste heat to generate steam and energy, they were puzzled that their boiler wasn't producing as much steam as expected.
R&R and Tetra Engineering Group Inc. were asked to solve the issue with reduced steam production.
An inspection had shown that a significant amount of hot flue gas was bypassing the boiler tubes, where the heat was supposed to be transferred.
R&R Consult conducted a CFD analysis, which revealed that 6.3% of the flue gas was bypassing the boiler tubes without transferring heat. The analysis also showed that the flue gas was instead being directed along the sides of the boiler and between the modules that were supposed to capture the heat. This was the cause of the reduced performance.
Based on our results, Tetra Engineering installed covering plates to reduce the bypass flow. This improved the boiler's performance and increased electricity production.
It is always satisfying when we can help solve complex challenges like this. Do your systems also need a check-up or optimization? Give us a call!
Work done in cooperation with James Malloy and David Moelling from Tetra Engineering.
More examples of our work https://www.r-r-consult.dk/en/cases-en/
Automobile Management System Project Report.pdfKamal Acharya
The proposed project is developed to manage the automobile in the automobile dealer company. The main module in this project is login, automobile management, customer management, sales, complaints and reports. The first module is the login. The automobile showroom owner should login to the project for usage. The username and password are verified and if it is correct, next form opens. If the username and password are not correct, it shows the error message.
When a customer search for a automobile, if the automobile is available, they will be taken to a page that shows the details of the automobile including automobile name, automobile ID, quantity, price etc. “Automobile Management System” is useful for maintaining automobiles, customers effectively and hence helps for establishing good relation between customer and automobile organization. It contains various customized modules for effectively maintaining automobiles and stock information accurately and safely.
When the automobile is sold to the customer, stock will be reduced automatically. When a new purchase is made, stock will be increased automatically. While selecting automobiles for sale, the proposed software will automatically check for total number of available stock of that particular item, if the total stock of that particular item is less than 5, software will notify the user to purchase the particular item.
Also when the user tries to sale items which are not in stock, the system will prompt the user that the stock is not enough. Customers of this system can search for a automobile; can purchase a automobile easily by selecting fast. On the other hand the stock of automobiles can be maintained perfectly by the automobile shop manager overcoming the drawbacks of existing system.
Quality defects in TMT Bars, Possible causes and Potential Solutions.PrashantGoswami42
Maintaining high-quality standards in the production of TMT bars is crucial for ensuring structural integrity in construction. Addressing common defects through careful monitoring, standardized processes, and advanced technology can significantly improve the quality of TMT bars. Continuous training and adherence to quality control measures will also play a pivotal role in minimizing these defects.
Overview of the fundamental roles in Hydropower generation and the components involved in wider Electrical Engineering.
This paper presents the design and construction of hydroelectric dams from the hydrologist’s survey of the valley before construction, all aspects and involved disciplines, fluid dynamics, structural engineering, generation and mains frequency regulation to the very transmission of power through the network in the United Kingdom.
Author: Robbie Edward Sayers
Collaborators and co editors: Charlie Sims and Connor Healey.
(C) 2024 Robbie E. Sayers
Courier management system project report.pdfKamal Acharya
It is now-a-days very important for the people to send or receive articles like imported furniture, electronic items, gifts, business goods and the like. People depend vastly on different transport systems which mostly use the manual way of receiving and delivering the articles. There is no way to track the articles till they are received and there is no way to let the customer know what happened in transit, once he booked some articles. In such a situation, we need a system which completely computerizes the cargo activities including time to time tracking of the articles sent. This need is fulfilled by Courier Management System software which is online software for the cargo management people that enables them to receive the goods from a source and send them to a required destination and track their status from time to time.
Cosmetic shop management system project report.pdfKamal Acharya
Buying new cosmetic products is difficult. It can even be scary for those who have sensitive skin and are prone to skin trouble. The information needed to alleviate this problem is on the back of each product, but it's thought to interpret those ingredient lists unless you have a background in chemistry.
Instead of buying and hoping for the best, we can use data science to help us predict which products may be good fits for us. It includes various function programs to do the above mentioned tasks.
Data file handling has been effectively used in the program.
The automated cosmetic shop management system should deal with the automation of general workflow and administration process of the shop. The main processes of the system focus on customer's request where the system is able to search the most appropriate products and deliver it to the customers. It should help the employees to quickly identify the list of cosmetic product that have reached the minimum quantity and also keep a track of expired date for each cosmetic product. It should help the employees to find the rack number in which the product is placed.It is also Faster and more efficient way.
About
Indigenized remote control interface card suitable for MAFI system CCR equipment. Compatible for IDM8000 CCR. Backplane mounted serial and TCP/Ethernet communication module for CCR remote access. IDM 8000 CCR remote control on serial and TCP protocol.
• Remote control: Parallel or serial interface.
• Compatible with MAFI CCR system.
• Compatible with IDM8000 CCR.
• Compatible with Backplane mount serial communication.
• Compatible with commercial and Defence aviation CCR system.
• Remote control system for accessing CCR and allied system over serial or TCP.
• Indigenized local Support/presence in India.
• Easy in configuration using DIP switches.
Technical Specifications
Indigenized remote control interface card suitable for MAFI system CCR equipment. Compatible for IDM8000 CCR. Backplane mounted serial and TCP/Ethernet communication module for CCR remote access. IDM 8000 CCR remote control on serial and TCP protocol.
Key Features
Indigenized remote control interface card suitable for MAFI system CCR equipment. Compatible for IDM8000 CCR. Backplane mounted serial and TCP/Ethernet communication module for CCR remote access. IDM 8000 CCR remote control on serial and TCP protocol.
• Remote control: Parallel or serial interface
• Compatible with MAFI CCR system
• Copatiable with IDM8000 CCR
• Compatible with Backplane mount serial communication.
• Compatible with commercial and Defence aviation CCR system.
• Remote control system for accessing CCR and allied system over serial or TCP.
• Indigenized local Support/presence in India.
Application
• Remote control: Parallel or serial interface.
• Compatible with MAFI CCR system.
• Compatible with IDM8000 CCR.
• Compatible with Backplane mount serial communication.
• Compatible with commercial and Defence aviation CCR system.
• Remote control system for accessing CCR and allied system over serial or TCP.
• Indigenized local Support/presence in India.
• Easy in configuration using DIP switches.