The Hydraulic Pressure Test Bench is used for testing of tube assembly of Maximum length 3965 mm. System can generate hydraulic pressure up to 500 bar. Air Driven High pressure pumps are used to generate high pressure, 6 bar air drive is required to operate the pump & control valves. Low pressure Pump is used for filling of water in test tube, it required single phase 230 V, 15 Amp Power. It is automatically controlled by PLC & HMI. System is divided in following sub parts- Air Drive section. Hydraulic Section. HMI & Electrical section. Test Chamber. Hydraulic Pressure Test Bench is used for testing of tube assembly of Maximum length 3965 mm. System can generate hydraulic pressure up to 500 bar.

3. The Hydraulic Pressure Test Bench is used for testing of tube assembly of Maximum length
3965 mm. System can generate hydraulic pressure up to 500 bar. Air Driven High pressure
pumps are used to generate high pressure, 6 bar air drive is required to operate the pump &
control valves. Low pressure Pump is used for filling of water in test tube, it required single
phase 230 V, 15 Amp Power. It is automatically controlled by PLC & HMI.
System is divided in following sub parts-Air Drive section.Hydraulic Section.HMI &
Electrical section.Test Chamber.

5.  Air Driven Liquid Pump .
 Safety Relief Valve.
 Electronic pressure regulator.
 Pressure Transmitter.
 Solenoid Valve.
 Ball Valve with Limit switch.

7. FRL Unit - Grid dimension 62 mm , End connection: 1/2 "
BSP Female Working Pressure: 10 Bar Operating Medium :
Air
Safety Relief Valve - MOC: Brass ,Set pressure : 2- 7 Bar,
Working Medium : Air
Electronic pressure regulator - Pressure Range 0.9Mpa
Pressure Transmitter - Size : 1/2" BSPM, Range: 0-16 Bar,
Output Rating : 4-20 mAmp, Accuracy : 0.25%
Solenoid valve - 3/2 way solenoid valve , working media Air ,
working pressure 8 bar , LINE SIZE 1/2''
Y type strainer - MOC : Brass , Size 1/2'' BSP
Check Valve - MOC : SS , Size 1/2'' BSP
Temperature transmitter - Measuring Range 0-100 Degree C

9. Application
Hydraulic Pressure Test Bench is used for testing of tube assembly of Maximum length 3965
mm. System can generate hydraulic pressure up to 500 bar.

10. Thank You