This document summarizes the design verification of a residential building using STAAD Pro software. It describes designing a G+1 residential building in Pudukottai using STAAD Pro to verify dimensions and analyze load combinations on the building's slab, beams and columns. Key steps included learning IS codes, designing the building, making Excel calculations, assigning loads in STAAD Pro, and verifying calculations match STAAD results. The analysis confirmed the building's safety under dead and live loads.

1. DESIGN VERIFICATION OF
A RESIDENTIAL BUILDING
By
K.Azarudeen-13BCL0096
S.Muthukumar-13BCL0304
P.Mohankumar-13BCL0327

2. PROBLEM DEFINITION
• Design Verification of a residential building using a software -
(Staad pro 2015) .
• Residential building of G+1 floor from a location(Pudukottai)
is taken for verification

3. THE DESIGNED PLAN OF BUILDING

5. SNAPS OF THE BUILDING

6. VALUES ADOPTED
• SLAB: 0.15m (depth)
• BEAM: 0.25m x 0.3m
• COLUMN: 0.3m x 0.3m
• LIVE LOAD: 3kN/m (maximum adopted)

7. DESCRIPTION
• The buildings live load and dead load is calculated from the type
of material used and the dimensions
• Dimensions of slab, beams, column, footing of a residential
building are verified for compliance to Indian Code
• M20 concrete and Fe415 steel have been used for this building
• The plan and photos of the building are provided.

8. 3D RENTERING OF THE RESIDENTIAL BUILDING

9. DEAD LOAD LIVE LOAD

10. LOAD COMBINATION OF DL & LL

11. EXCEL SHEET FOR RECTANGULAR BEAM CHECK

12. EXCEL SHEET FOR ONEWAY SLAB CHECK

13. EXCEL SHEET FOR TWOWAY SLAB CHECK

14. Learning basics of IS
CODE Books
Designing a
residential building
Make an Excel
calculation to
design
Beam,Coloumn,
Slab
Analysing the building
in STAAD pro and
conclusion
Learning
basics of
STAAD PRO
Steps involved

15. PARAMETERS 1st
2nd
3rd
4th
1st
2nd
3rd
4th
1st
Learning basics of
STAAD PRO
Learning basics of
IS
CODE Books
Designing a
residential building
Make an Excel
calculation to
design
Beam,Coloumn,
Slab
Verify the
calculation values
to STAAD PRO
2nd
3rd
4th
1st
2nd
3rd
4th
JULY AUGUST SEPTEMBER OCTOBER
ACTIVITY CHART

16. ERRORS & MISTAKES
• Error caused in assigning the dimensions to the
particulars
• Beams were not intersected properly which leads to error
in calculation
• Not intersecting the slabs.
• Assigning live load in wrong directions.
• Worksheet assigning errors.
• Assuming wrong standard values in calculations.

17. LEARNIGS
• Design a building using STAAD pro for
• 1)Dead load and live load assigning
• 2)Dimension assigning
• 3) Basic kinds of possible errors
• 4) Problems in automatic load design.
• Learned to use excel sheet.
• IS 875(part2) for residential building.
• Basic design of Beams, Colums, Slabs in worksheet and
hand calculations.

18. REFERENCES
• IS: 875(part 1), IS: 875(part 2)
• IS 456:2000, SP-16
• https://youtu.be/Ae44Fp8JmKE
• staad pro and excel tutorials from youtube

19. CONCLUSIONS
• The resistance to the live load and dead load is verified
for beams,columns,and slabs of the building.
• The results were compared to the actual plan and the
safety criteria is checked.