what is the Matlab code of the two functions, I want to plot them in Matlab m,n vary from -50 to 50 c. (7%) fam, n) sin m) cos n), where m and n vary from d. (7%) f(x, y) sin (r) cos y), where x and y vary from Solution t = 0:0.01:(2*pi); x = cos(t); y = sin(t); plot(t,x,\'k\'); hold on; plot(t,y,\'r-.\'); axis([0 2*pi -1.5 1.5]) legend(\'cos(t)\',\'sin(t)\',\'Location\',\'.

1. You are carrying out experiments in cell fusion by fusing together cells at different stages of the
cell cycle. You then observe the behavior of each nucleus residing in the combined cytoplasm of
the two cells. Which of the following responses would occur if you fused a G_1 cell to a cell in
the M phase? The nucleus from the G_1 cell started to replicate its DNA. The G_1 nucleus
undergoes premature chromosomal condensation to form a set of elongated compacted
chromosomes. The M phase nucleus is affected in such a way that its compacted chromosomes
decondense. The G_1 nucleus did initiate DNA synthesis, and the M phase nucleus stopped
chromosome condensation.
Solution
answer is the M phase nucleus is affected in such a way that its compacted chromosomes
decondense.
because,if a an Interphase cell is fused with a cell at M stage the Interphase cells directly enter
into M-phase with disastrous consequences. The Interphase cell is not yet competent to enter into
M phase, but M phase cells have all the components for chromosomal separation. So there is
regulation at each of the entry points called check points, which is tightly regulated.