HARDNESS, IMPACT TEST, TENSILE AND COMPRESSION

1. Mechanical tests of metals
Destructive tests

2. Classification of mechanical tests
• Destructive test
• Non – Destructive test

3. Tensile test
destructive test – ductile material

4. We find

5. .

6. .

7. .

8. .

9. .
A

10. CALCULATION

11. .

12. .

13. .

14. COMPRESSION TEST
• Brittle material used ( cast iron, brick, concrete)
• Same UTM Machine used

15. measurement
• Compression load is gradually applied on the
specimen and the reduction in length is
recorded

16. Shear test
Pure shear force applied
To measure shear strength

17. Pure Shear force
• A pure shear force
applied top and bottom
parallel to its faces
• Double shear system
used to measure the
shear stress and shear
strain.

18. .

19. Limitations of shear test
• Need attachment with UTM machine .
• Material at last gets bend
• So we will get the bending stress also, not the
pure shear type.
• Very difficult in processing

20. Torsion test
• Rotational force given to material about longitudinal
axis.

21. .

22. HARDNESS TEST
Brinell Hardness
Vickers Hardness
Rockwell Hardness

23. Definition

24. Types
• Brinell Hardness
• Vickers Hardness
• Rockwell Hardness

25. Brinell hardness test

26. Hardness test is performed by pressing a steel ball also known as
indenter, into the specimen

27. .

28. .

29. Vickers hardness test
High accuracy than brinell due to
square based diamond pyramid
indenter

30. .

31. .

32. .

33. .

34. Rockwell hardness test
Industries used due to its high
accuracy, simplicity and rapidity

35. Highlights
• In this test , the dial gives the direct reading of
hardness; no need of measuring indentation
diameter or diagonal length using the microscope

36. .

37. advantages
• Simple
• Reading taken directly
• Time consuming process
• Suitable for mass production
• We can measure any range of value with
various indenters.
• Metallic and also plastics used

38. limitations
• Its not accurate than vickers test

39. IMPACT TEST-
TO STUDY THE BEHAVIOUR OF THE MATERIAL UNDER SUDDEN LOAD
IZOD TEST
CHARPY TEST

40. IMPACT STRENGTH
• The ability of the material withstand a
blow(force) without fracture

41. .

42. IZOD TEST
Izod test uses cantilever specimen of
size 75mm×10mm×10mm.
The V-notch angle is450 and depth of
the notch is 2mm.
The Izod specimen is placed in the vise
such that it is a cantilever.

43. Charpy test

44. FATIGUE TESTS
• The capacity of material to withstand repeatedly
applied stresses is known as fatigue

45. FATIGUE TESTS

46. Creep test
• The continuous deformation of a metal under
a steady load is known as creep.
• The purpose of creep tests is to determine the
creep limit.
• The creep limit or the limiting creep stress is
defined as the stress that will not break the
specimen when applied for an infinite period
at a specific constant temperature.

48. BASIC REQUIREMENTS FOR CREEP TEST
• It must posses means for applying and
maintaining a constant load
• There must be a furnace capable of keeping
the temperature of the test- piece at the
desired value to within very close limits.
• There should be means for the measurement
of test- piece extension.