To work a cable network, you must know the tools and wire colors. The standard cable has 8 wires in a specific color order inside the RJ connector. You use wire cutters to strip the cable, then insert the RJ connector into the network piston. Finally, you test the cable using a tester device to check if the lights for each wire pair are working properly according to the standard.

1. How to work Cable Network

2. OUT LINE Know the tool for work

3. Know the color of wire in cable

4. 8-wire standard

5. Order color in RJ

6. Test the cable Tools CutterToolsRJ ToolsCable NetworkToolsTesterToolsPiston networksHow to wire the networkUsing a wire cutter undressColor of wire in cableEach cable consisting of 8 wiresColorsGreen and green – whiteBlue and blue - whiteOrange and orange - whiteBrown and Brown - White

7. 8-wire standard

8. Order color Order of colors depending on the basic standardsHow to wire the networkOrder of colors inside the RJ

9. Order color in rjOrder of colors inside the RJ

10. Order color in rjOrder of colors inside the RJ

11. Put RJ in pistonAfter that is put the RJin the piston network

12. Test the cableEnter the cable in tester device If the cable is ready for use must work all the headlamp according to the following1-32-63-14-45-56-27-78-8

13. The EndThank you for listeningby: Isra’a Al Jarrah2008901081Computer ScienceA. Mohammad Ramahi