This document contains instructions for an engineering drawing examination with two parts - Part A and Part B. Part A contains 4 questions worth 5 marks each, requiring skills like lettering, dimensioning, construction of shapes. Part B contains 4 questions worth 10 marks each involving more complex multi-view drawing of objects like prisms, cylinders based on cut section views and development of surfaces. The document provides guidance on time duration, marking scheme and expectations in terms of neatness and dimensioning from the candidates.

1. 046
046
046
046
*
*
*
C14–EE–107
4044
BOARD DIPLOMA EXAMINATION, (C–14)
OCT/NOV—2016
DEEE—FIRST YEAR EXAMINATION
ENGINEERING DRAWING
Time : 3 hours ] [ Total Marks : 60
PART—A 5×4=20
Instructions : (1) Answer all questions.
(2) Each question carries five marks.
(3) Drawing should be neat and clear with the necessary
dimensions.
(4) All dimensions are given in mm, unless until
specified.
1. Write the following sentence in single-stroke vertical lettering 10
mm size in capital letter :
ALWAYS DO YOUR BEST
2. Redraw the given figure to full scale using progressive
dimensioning :
/4044 1 [ Contd...
* 4 0 4 4 *

2. 046
046
046
046
*
*
*
3. Construct a regular pentagon of 50 mm side using general method.
4. The front view and top view of an object are given in the figure
below. Draw the auxiliary view of the sloping side of the object :
PART—B 10×4=40
Instructions : (1) Answer any four questions.
(2) Each question carries ten marks.
(3) Drawing should be neat and clear with the necessary
dimensions.
(4) All dimensions are given in mm, unless until
specified.
5. The major axis of an ellipse is 100 mm and length of minor axis is
70 mm. Construct an ellipse and also draw a tangent at any point
on it.
/4044 2 [ Contd...

3. 046
046
046
046
*
*
*
6. Draw any two views of the object shown in the figure below if the
front view is in the direction of x and side view is in the direction of
y and top view is in the direction of z :
7. A regular pentagonal prism of side of base 40 mm and height
80 mm has its base in HP and one of its rectangular face making
45° to the VP. It is cut by a section plane inclined at 60° to the HP
and perpendicular to VP and passing through the centre of the top
face. Draw its sectional top view and front view.
8. The front view and right side views of an object is as shown below.
Draw its pictorial isometric view :
9. A hexagonal prism of base 25 mm and height 70 mm is standing on
HP with one of its base edges parallel to VP. It is cut by a section
plane, inclined at 45° to HP and passing through the point on axis
which is at a distance of 35 mm from ground. Draw the
development of lateral surface of prism.
/4044 3 [ Contd...

4. 046
046
046
046
*
*
*
10. A cylinder of base diameter 35 mm and axes 60 mm is inclined at
30° to HP. It is cut by a sectional plane parallel and inclined at 10°
HP bisects the axis. Draw the sectional front and top views.
H H H
/4044 4 AA6(T)—PDF