Double Side Band SC using LabVIEW this slideshow is about how to design a Double Side Band SC using LabVIEW to see the illustration video https://youtu.be/YW0BMRm0k54

1. LabVIEW COURSE FOR
COMMUNICATION
ENGINEERS
DSB-SC
MODULATION
SOFTWARE AWARE

2. 1- open LabVIEW
2- click Create Project

3. 2-choose Blank VI then click Finish

4. Block Diagram and Front Panel windows will appears

5. This is the block diagram we want to design

6. open block diagram window and right click by the mouse

7. create a while loop>>>> all the components will be inserted in the while loop

8. right click on red button and choose create control

9. to create the message signal.......... signal processing >> wfm generation >> simulate signal

10. double click on simulate signal the set the configuration as shown

11. set also the the carrier signal but with these different configuration

12. insert multiplier to multiply (mixer) the two signals

13. then connet the structure as following

14. right click on the path >> Create >> Graph indicator

15. insert the spectrum analyzer

16. after adding the spectrum analyzer

17. add graph indicator at the o/p of the multiplier and the spectrum analyzer

18. go to front panel and arrange the component >>then click run in the above toolbar

19. to see the full video go to the link in the description
THANK YOU