This PPT is uploaded by MOHD WASHIQUE AHEMAD during the academic of 3rd year in Feroze gandhi institute of engineering and technology, Raebareli under the guidance of Assistant professor Mr. Shardul singh M.TECH(IIT ROORKEE)

1. HYPERLOOP
Transportation
The fifth mode of transportation
Presented by- Mohd Washique Ahemad
Presented to - Mr. Shardul Singh
Mr. Tauqueer

2. Overview
2
Introduction
History
Concept
Conventional Modes Of Transportion
Advantages
Limitations

3. Introduction
3
A Hyperloop would be "an
elevated, reduced-pressure tube
that contains pressurized capsules
driven within the tube by a number
of linear electric motors.”

4. History
4
Proposed by ELON MUSK American business magnate, investor, and inventor.
He is currently the CEO & CTO of SpaceX and CEO & Chief Product
Architect of Tesla Motors.
A high-level alpha design forthe system was published onAugust 12, 2013.

5. • Low pressure tube with capsules that move back and forth
throughout the length of the tube.
• Accelerated via a linear magnetic accelerator.
• Supported on a cushion of air.
• Proposed route from Los Angeles to San Fransisco (approx. 560 km).
To be covered in just 35 minutes, with capsules leaving end stations
every 2 minutes
Concept

6. CONVENTIONAL MODES OF TRANSPORTATION:
6
1. RAIL relatively slow and expensive
2. ROAD relatively slow
3. WATER relatively slow
4. AIR expensive

7. Components of Hyperloop TransportationSystem
7
1. Capsule
2. Tube
3. Propulsion

8. 1. CAPSULE
8
• Sealed capsules carrying 28
passengers
• The maximum width is 4.43 ft (1.35
m) and maximum height is 6.11 ft
(1.10 m). With rounded corners

9. Contd;
Hyperloop passenger capsule version with doors open at the station.
9

10. Contd;
Hyperloop passenger capsule version cutaway with passengers onboard.
10

11. 2.TUBE
11
• The expected pressure inside
the tube will be maintained
around 100pa (less pressure).
• The inner diameter of the tube
is optimized to be 7 ft 4 in.
(2.23 m)

12. Contd;
Hyperloop capsule in tube cutaway with attached solar arrays.
12

13. 3.PROPULSION
13
Linear accelerators are constructed
along the length of the tube at
various locations to accelerate the
capsules.

14. Rotor (mounted tocapsule)
Stator (mounted totube)
Rotor and stator 3D diagram
14

18. Advantages
18
Inexpensive (road)
Fast (air)
Environmentally friendly (rail/road via electriccars)
Sustainable (uses solar energy)
Runs through the median of existing highway

19. Limitations
19
A number of economists and transportation experts have expressed the
belief that the US$6 billion price tag dramatically understates the cost of
designing, developing, constructing and testing an all-new form of
transportation.

20. THANKYOU
20