3. First I made sure that the page was on an A4 setting i did this by going to file- new-blank file. Then I opened up my image from my documents. Because one of my models in the picture is a lot lighter I had to change the lightness of the image by going to hue and saturation and changing the brightness, to make the image darker, so that I could see the features of the lighter model.
4. After I duplicated the background layer, and I wanted to blur the background and have the three models stand out more, to blur the whole image on the duplicated layer I went to filter-blur-Gaussian blur and changed the blurriness of the photo to at least 1.2-3 pixels. After this I used the rubber tool and began to rub away the areas on the models ONLY so that the look sharp and stand out more. As I did this I made sure that I didn’t use the rubber to erase any of the blurriness in the background.
5. After this I used an effect on the whole picture called overlay. Which seemed to merge the colours in the background together.
