1) The document discusses a group project on developing a nitrogen gas injection system to fight mine fires. The group members are Abhishek Kumar, Manish Raj, and Vihang Bhalla, under the guidance of Dr. Santanu Bhowmik. 2) The objectives are to study the different sources of heat in underground coal mines, how different forms of nitrogen gas can be used to control fires, methods of using such gases, and how gas generators can be readily available. 3) It is proposed that installing nitrogen generators at mine sites prone to fires could effectively control fires in a timely manner through continuous nitrogen injection. The generators should be portable, capable of augmentation, and suitable for harsh

1. Minor-1 (Mid sem presentation)
Group Members:
1) Abhishek Kumar (R136215001)
2) Manish Raj (R136215017)
3) Vihang Bhalla (R136215036)
Under Guidence Of
Dr Santanu Bhowmik
Title- “NITROGEN GAS INJECTION SYSTEM FOR FIGHTING MINE
FIRES

2. INTRODUCTION
 Coal absorbs oxygen even at lower temperature than the
ambient temperature and they start heating up.
 When heat of dissipation is less than the heat of
accumulation then coal bed temperature increases and
ultimately leading to fire.
 Nitrogen injection can be used to control fire along with
pressure balancing.
 Nitrogen gas is cold and dry and poses no problem with
cooling or compression.
 N2 can be delivered in fire area in liquid form or in gaseous
form through piping arrangement .

3. OBJECTIVE
1. To study difference sources of heat in
underground coal mines.
2. To study how different form of nitrogen gas can
be used to control mine fires.
3. Method of using such gases.
4. How gas generators can be readily available in
quick time at mine site.

4. PROBLEM STATEMENT
 Spontaneous Combustion: The coal seam areas are
rich in carbonaceous matters. The oxidation of these
carbon content matters at an ambient temperature is
the main cause of spontaneous combustion.
 Methane Explosion: The main reason behind the
mine fire caused by methane is due to the formation of
fire damp.
 Coal Dust Explosion: It is generally initiated by other
explosion such as spontaneous combustion or
methane explosion. Coal dust mixed into air provide a
vast surface area of exposure, they get vulnerable to
immediate burning.

5. LITERATURE REVIEW
 Mechanism of mine fire: The main mechanism of
spontaneous heating is absorbing the oxygen from atmosphere
and decomposing into various carbon and oxygen complexes.
This process generally liberates heat. Coal when absorbs oxygen
it heats up because oxidation of coal in presence of air is
exothermic. Up to 50o c the oxidation is very slow, when it
reaches up to 80 o c the oxidation rate is increased and when
reaches near 120 o c, the water evaporates and moisture of the
coal gets released. Here the oxidation is faster and steady. The
evolution of oxidation of carbon starts when the temperature is
from 120 to 180 o c. At this temperature up to 220 o c, thermal
decomposition of coal starts. When the temperature increases
from 220 o c to 275 o c coal starts self-sustained process of
combustion. When the temperature rises from 275 o c, coal starts
active combustion which sometimes can lead to ignition.

6. LITERATURE REVIEW (cont…)
 FIRE PREVENTION USING NITROGEN FLUSHING:
The technology of Nitrogen infusion for fire combat activities in
underground mines may be divided broadly in four categories as
follows:
 Replacement of air with nitrogen gas in goaf vulnerable to
heating leading to prevention of gas explosions by modifying the
atmosphere.
 Replacement of air before sealing a district where heating has
been detected by reducing the intensity or spread of secondary
combustion and to cool the area surrounding the fire zone.
 Control and extinction of fire in sealed off area by Nitrogen gas
infusion with pressure chambers for safety and recovery.
 Protecting shaft pillars and ribs adjoining main and haulage road
from advancing fire by putting up Nitrogen gas plug.

7. Literature review (cont…)
 An attempt was made to control an old fire, which
started in the 50s , in Laikdih deep colliery, Bharat
Coking Coal Ltd. (BCCL) with N2 plant in March
1981. Only partial success was achieved because of
heavy leakage into the fire section of the mine.
However, on the grounds of this experience, a
breakthrough was achieved in extinguishing
underground mine fire with N2 technology.

8. Literature review (cont…)
 The data from following mines were selected:
 Kottadih Colliery (Raniganj Coal Fields) ;In April 1997,
there was sudden strata collapse due to the spontaneous
heating. Fire was controlled by drilling nine boreholes and
injecting nitrogen into those boreholes.
 Sijua Colliery (TISCO); fire was brought under control by
installing a N2 generator of nitrogen injection capacity
500m3/hr.
 Lodna Colliery; an underground fire was advancing , the
fire was initially fought with liquid N2 transported to mine.
Subsequently, a PSA type N2 generator was installed.

9. CONCLUSION
 The main difficulty with nitrogen gas injection
methods has been the limited availability of plant
to provide large volumes of gas on site at short
notice.
 With continued injection of N2 gas, the fire
remained dormant.

10. FUTURE PROPOSED WORK
 If Nitrogen generators can be installed at mine site
where there is greater probability of fire, It can be
effectively controlled on time.
 Effective use of nitrogen for extinguishing mine fire
can be provided with N2 generator of following
characteristics:
 Modular construction to facilitate both portability as
well as capacity augmentation.
 Equipment and system design should be suitable for
operating in the typically harsh mining environment.

11. FUTURE PROPOSED WORK (cont…)
 The system should be compatible with the existing
compressed air supply wherever applicable.

12. REFERENCES