This document discusses 8051 microcontroller programming and contains instructions for setting bits, jumping to relative addresses, subtracting bytes, swapping registers, exchanging registers and memory, and performing exclusive OR logic operations on registers and memory locations. It was created by Prof. Anish Goel for an embedded systems course covering 8051 microcontroller programming.

1. 8051 Microcontroller
Programming Part - D
Prof. Anish Goel
Embedded Systems

2. Embedded Systems Prof.Anish Goel2
SETB <bit>

3. Embedded Systems Prof.Anish Goel3
SJMP rel

4. Embedded Systems Prof.Anish Goel4
SUBB A,<src-byte>

5. Embedded Systems Prof.Anish Goel5

6. Embedded Systems Prof.Anish Goel6
SWAP A

7. Embedded Systems Prof.Anish Goel7
XCH A,<byte>

8. Embedded Systems Prof.Anish Goel8
XCHD A,@Ri

9. Embedded Systems Prof.Anish Goel9
XRL <dest-byte>,<src-byte>