1. Rig #: BENNEVIS PIC Signature Approving JSA:
Work Activity (Job): MA 026 TRANSFER FUEL / BASE OIL / OBM to or FROM SUPPLY BOAT
Work Team (Crew Members): DECK CREW - CRANE OP – BARGE ENGINEER - MUD ENGR (FOR OBM and Base OIL) Rev.
Sequence of Basic Job Steps Potential Accidents or Hazards Recommendation to Eliminate or Reduce Potential Hazards
Who?
Initials
- EQUIPMENT PREPARATION
- CRANE & LIFTING GEAR
INSPECTION
- PERFORM RADIO CHECK W/
CRANE & SUPPLY BOAT
- CHECK SEA CONDITIONS
- SLING IN POOR CONDITION
- NIGHT TRANSFER SHOULD BE AVOIDED /
POLLUTION
- ALL PARTS NOT AWARE
- WORK PERMIT MANDATORY
- NO LOADING OF FUEL OIL (diesel) WHEN BJ UNIT IN
OPERATION ON STBD SIDE
- HAND HELD VHF
- EXTRA FLOOD LIGHT TO BE SWITCHED ON
- INFORM DRILLER, MUD LOGGER and PUMP MAN
ABOUT OPERATION (OBM and BASE OIL).
- ALL TANK LEVEL MUST BE CHECKED PRIOR TO
STARTING THE TRANSFER
- LIFTING HOSE FROM STATION
- TRANSFER HOSE TO BOAT
- HOSE FALLING
- PINCH POINTS
- MAN FALL OVERBOARD
- SPILLAGE
- VISUALLY CHECK LIFTING GEAR
- MIN 2 PERSONS TO CONNECT HOSE
- WORK VEST TO BE USED
- ONLY 1 BANKSMAN TO GIVE SIGNALS
- ENSURE END CAP IN PLACE
- STAND CLEAR OF SUSPENDED HOSE, BARRIER THE
AREA
- START TRANSFER
- AFTER TRANSFER RETURN
HOSE TO RIG
- WRONG TANK LINED UP
- HOSE BURST
- HOSE LEAKS
- DAMAGE TO THE HOSE
- POLLUTION ( SEA AND / OR TENDER)
- ALL TANK LEVEL MUST BE CHECKED BY PUMP MAN
and BARGE MASTER DURING THE TRANSFER AND
CONTROLLED AT THE END. STOP IF ABNORMAL
CHANGES.
- DOUBLE CHECK ALL RELEVANT VALVES OPENED
- KEEP VISUAL ON HOSE DURING TRANSFER
(WATCHMAN POSTED ON THE DECK)
- CHECK IF FLUID IS ARRIVING IN THE CORRECT
TANK
- NO OFF LOAD / BACKLOAD DURING THE
OPERATION ( ABOVE THE HOSE )
- ENSURE END CAP ON HOSE
- BOAT PROVIDED WITH SPILLAGE DISPERSING KIT +
- SPILLAGE CONTROL KIT ( IN SACK ROOM )
Safety Equipment To Do This Job
Hard Hats ( Cotton Gloves ( Face Shield ( Fire Extinguishers (
Safety Boots ( Work Vest ( Goggles ( Lockout/Tagout (
Safety Glasses ( Safety Harness ( Barricades ( Work Permit Required (
Page 1
Pyramid Drilling S.A
Manual Title: Personnel Safety Manual
Form Name: Job Safety Analysis
Issue Date
02-Sept-07
Revision No.
2
Revision Date
04-MAR 08
Prepared By
QA/HSE
Approved By
HM
Level No.
2

2. Page 2
Pyramid Drilling S.A
Manual Title: Personnel Safety Manual
Form Name: Job Safety Analysis
Issue Date
02-Sept-07
Revision No.
2
Revision Date
04-MAR 08
Prepared By
QA/HSE
Approved By
HM
Level No.
2