This document discusses using Tinker CAD software to simulate sensors and circuits with and without Arduino. It provides an agenda that includes an introduction to Tinker CAD, hands-on use of the software, circuit simulations without and with Arduino, and developing systems for specific applications like a non-contact doorbell, intruder detection, and smoke detection. It describes learning outcomes of being able to use Tinker CAD to design and simulate circuits and develop embedded systems. It then shows several circuit simulations using components like LDRs, temperature sensors, push buttons, and buzzer. Finally, it demonstrates simulations with Arduino, including a buzzer with push button, PIR sensor, ultrasound sensor, and smoke detector circuits.

1. Sensors and Arduino Simulation
with
Tinker CAD
By
Dr.CH.Renu Madhavi

2. * Dept. of E & IE. 2
AGENDA
∙ Introduction of “TINKER CAD”
∙ Hands on “TINKER CAD” software
∙ Circuit simulations
∙ i)without Aurduino
∙ ii)With Aurduino
∙ Development of a system for specific application
∙ Non contact doorbell
∙ Intruder detection
∙ Smoke detection

3. * Dept. of E & IE. 3
TINKER CAD LOG IN CREATION

4. * Dept. of E & IE. 4
TINKER CAD LOG IN CREATION

5. LDR PHOTO DIODE TEMPERATURE
SENSOR
GAS
SENSOR
PROXIMITY
SENSOR
ULTRASOUND
SENSOR
BUZZER
COMPONENTS
AND GATE
555 TIMER 5V SUPPLY

6. FUNCTION
GENERATOR
POWER SUPPLY
OSCILLOSCOPE
MULTIMETER
INSTRUMENTS

7. * Dept. of E & IE. 7
LEARNING OUTCOMES
Able to use “TINKER CAD”
✔ For Designing circuits
✔ Simulation of the designed circuits
✔ Development of an Embedded system for any specific
application

8. * Dept. of E & IE. 8
CIRCUIT SIMULATION with LDR

9. * Dept. of E & IE. 9
DC MOTOR SPEED CONTROL

10. * Dept. of E & IE. 10
LED INTENSITY CONTROL

11. * Dept. of E & IE. 11
RC CIRCUITS

12. * Dept. of E & IE. 12
ANALOG INTEGRATED CIRCUIT

13. * Dept. of E & IE. 13
TEMPERATURE SENSOR SIMULATION

14. * Dept. of E & IE. 14
PUSH BUTTON AND BUZZER

15. * Dept. of E & IE. 15
Voltage divider

16. * Dept. of E & IE. 16
CIRCUIT SIMULATION –PIR SENSOR

17. * Dept. of E & IE. 17
Aurduino (set /Reset Led on Pin3 )

18. * Dept. of E & IE. 18
SIMULATION WITH AURDUINO

19. https://www.tinkercad.com/things/l6XEoJCmhyA-brave-
turing/editel?tenant=circuits
Dept. of E & IE. 19
BUZZER WITH PUSHBUTTON

20. * Dept. of E & IE. 20
SIMULATION WITH AURDUINO

21. * Dept. of E & IE. 21
PIR SENSOR

22. * Dept. of E & IE. 22
ULTRASOUND SENSOR

23. * Dept. of E & IE. 23
SMOKE DETECTOR

24. PIR SENSOR WITH SERIAL MONITOR

25. INTERFACING LCD

26. * Dept. of E & IE. 26
COMPONENTS
BATTERY
AURDUINO
BREAD BOARD DC MOTOR PUSH BUTTON

27. Voltmeter using LCD

28. THANK YOU