This document summarizes the front panel controls and specifications of a signal generator, including its ability to generate sine waves from 10Hz to 1MHz at amplitudes from 5mV to 5V, square waves from 0-20V with adjustable symmetry from 30-70%, and various other waveforms from a function generator such as ramps and pulses for testing applications. It operates on 220V 50Hz power and requires only 7W of power.

1. SIGNAL GENERATOR
Signal Generator Fundamentals

5. AF SINE AND SQUARE WAVE GENERATOR
FRONT PANNEL CONTROLS:
1. Frequency selector
2. Frequency Multiplier
3. Amplitude Multiplier
4. Variable amplitude
5. Symmetry Control
6. Amplitude
7. Function Generator
8. Output Variable
9. Sync
10. ON-OFF

6. Specifications:
 Frequency - 10Hz to 1MHz, 5decades.
 Sine wave - 5mV to 5V(rms).
 Square wave – 0-20V(peak).
 Square wave symmetry is adjusted from 30% - 70%.
 O/p is taken from push-pull amplifier with low o/p
impedance.
 At 220V,50Hz, AF Signal generator requires 7W of
power only.

7. Function Generator:
• Diff waveform of adjustable frequency
• Various o/p at same time.
• Capability of Phase lock.
• Square wave- for testing linearity measurement
• Sawtooth- to drive horizontal deflection amplifier of
an oscilloscope.
• Frequency Control

9. Square and Pulse generators:

10. Square and pulse wave generator:

11. Specification:

12. Requirements of a pulse: