This document outlines procedures for conducting calorimetric measurements and evaluating calorimetric losses. It discusses measuring calorimetric quantities, determining losses from the quantities, and evaluating the losses. The document provides definitions and references other documents. It describes the measuring equipment and accuracy requirements. Sections also cover determining efficiency and procedures for deviations from nominal values.

1. Calorimetric Measurements and Evaluation of Calorimetric losses
Table of Content:
1 Objective........................................................................................................
2 Scope.............................................................................................................
3 Referenced Documents.................................................................................
4 Definitions and Abbreviations........................................................................
5 General...........................................................................................................
5.1 Measured calorimetric quantities.....................................................
5.2 Determination of losses from calorimetric quantities.......................
5.3 Evaluation of calorimetric losses.....................................................
6 Conduction of test...........................................................................................
7 Measuring equipment.....................................................................................
7.1 Measuring devices and installation requirements........................................
7.2 Measuring accuracy.....................................................................................
8 Determination of efficiency..............................................................................
9 Proceeding in case of deviations....................................................................
Page 1 of 7

2. Page 2 of 7

3. Page 3 of 7

4. Page 4 of 7

5. Page 5 of 7

6. Page 6 of 7

7. 9 Proceeding in case of deviations
Any nominal value, minimum value, maximum value, tolerance etc given in an instruction
is intended to serve for quality control purposes only. In the case of deviations, a
nonconformity report has to be written according to PNG Power Standard
10 This Document is properly of PNG Power internal use only and must neither be
copied. Neither is it to be handed over nor in other way communicated to a third party.
Infringement will lead to prosecution.
Page 7 of 7