Computer and Network Engineering

1. Konfigurasi Router Jakarta
Router>enable
Router#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname Jakarta
Jakarta(config)#int fa 0/0
Jakarta(config-if)#ip address 193.34.24.1 255.255.255.0
Jakarta(config-if)#no shut
Jakarta(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to
up

2. Jakarta(config-if)#exit
Jakarta(config)#int se 0/0
Jakarta(config-if)#ip address 193.42.55.1 255.255.255.0
Jakarta(config-if)#no shut
%LINK-5-CHANGED: Interface Serial0/0, changed state to down
Jakarta(config-if)#clock rate 64000
Jakarta(config-if)#exit
Jakarta(config)#int se 0/1
Jakarta(config-if)#ip address 172.16.0.2 255.255.0.0
Jakarta(config-if)#no shut
Jakarta(config-if)#
%LINK-5-CHANGED: Interface Serial0/1, changed state to up
Jakarta(config-if)#exit
Jakarta(config)#exit
Jakarta#
%SYS-5-CONFIG_I: Configured from console by console
Jakarta#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]

3. Konfigurasi Ip Route
Jakarta(config)#ip route 193.46.54.0 255.255.255.0 193.42.55.1
%Invalid next hop address (it's this router)
Jakarta(config)#ip route 193.46.54.0 255.255.255.0 193.42.55.2
Jakarta(config)#ip route 193.16.10.0 255.255.255.0 172.16.60.2
Jakarta(config)#ip route 10.0.0.0 255.0.0.0 172.16.0.1
Jakarta(config)#exit
Jakarta#
%SYS-5-CONFIG_I: Configured from console by console
Jakarta#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]
Jakarta#

4. Konfigurasi Router Batam
Router>enable
Router#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname Batam
Batam(config)#int fa 0/0
Batam(config-if)#ip address 193.46.54.1 255.255.255.0
Batam(config-if)#no shut
Batam(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to
up
Batam(config-if)#exit
Batam(config)#int se 0/0
Batam(config-if)#ip address 172.16.60.1 255.255.0.0
Batam(config-if)#no shut
%LINK-5-CHANGED: Interface Serial0/0, changed state to down
Batam(config-if)#clock rate 64000
Batam(config-if)#exit
Batam(config)#exit
Batam#
%SYS-5-CONFIG_I: Configured from console by console
Batam#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]

5. Konfigurasi Ip Route
Batam>enable
Batam#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Batam(config)#ip route 193.34.24.0 255.255.255.0 193.42.55.1
Batam(config)#ip route 193.16.10.0 255.255.255.0 172.16.60.2
Batam(config)#ip route 10.0.0.0 255.0.0.0 193.18.4.2
Batam(config)#exit
Batam#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]

7. Konfigurasi Router Jawa
Router#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname Jawa
Jawa(config)#int fa 0/0
Jawa(config-if)#ip address 193.16.10.3 255.255.255.0
Jawa(config-if)#no shut
Jawa(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to
up
Jawa(config-if)#exit
Jawa(config)#int se 0/1
Jawa(config-if)#ip address 172.16.60.2 255.255.0.0
Jawa(config-if)#no shut
Jawa(config-if)#
%LINK-5-CHANGED: Interface Serial0/1, changed state to up
Jawa(config-if)#exit
Jawa(config)#int
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1, changed state to

8. Jawa(config)#int se 0/0
Jawa(config-if)#ip address 193.18.4.1 255.255.255.0
Jawa(config-if)#no shut
%LINK-5-CHANGED: Interface Serial0/0, changed state to down
Jawa(config-if)#clock rate 64000
Jawa(config-if)#exit
Jawa(config)#exit
Jawa#
%SYS-5-CONFIG_I: Configured from console by console
Jawa#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]
Jawa#

9. Konfigurasi Ip Route
Jawa>enable
Jawa#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Jawa(config)#ip route 193.34.24.0 255.255.255.0 193.42.55.1
Jawa(config)#ip route 193.46.54.0 255.255.255.0 172.16.60.1
Jawa(config)#ip route 10.0.0.0 255.0.0.0 193.18.4.2
Jawa(config)#exit
Jawa#
%SYS-5-CONFIG_I: Configured from console by console
Jawa#copy running start
Destination filename [startup-config]?
Building configuration...
[OK]
Jawa#

10. Konfigurasi Router Kalimantan
Router#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname Kalimantan
Kalimantan(config)#int fa 0/0
Kalimantan (config-if)#ip address 10.10.11.1 255.0.0.0
Kalimantan (config-if)#no shut
Jawa(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to
up
Kalimantan (config-if)#exit
Kalimantan (config)#int se 0/0
Kalimantan (config-if)#ip address 172.16.0.1 255.255.0.0
Kalimantan (config-if)#no shut

11. Kalimantan (config-if)#
%LINK-5-CHANGED: Interface Serial0/1, changed state to up
Kalimantan (config-if)#exit
%LINK-5-CHANGED: Interface Serial0/0, changed state to down
Kalimantan (config-if)#clock rate 64000
Kalimantan (config-if)#exit
Kalimantan (config)#exit
Kalimantan #
%SYS-5-CONFIG_I: Configured from console by console
Kalimantan #copy running start
Destination filename [startup-config]?
Building configuration...
[OK]
Konfigurasi Ip Route
Kalimantan>enable
Kalimantan#conf term
Enter configuration commands, one per line. End with CNTL/Z.
Kalimantan(config)# ip route 193.34.24.0 255.255.255.0 172.16.0.2
Kalimantan(config)# ip route 193.46.54.0 255.255.255.0 172.16.60.1
Kalimantan(config)#ip route 193.16.10.0 255.255.255.0 193.18.4.1
Kalimantan(config)#exit
Kalimantan#
%SYS-5-CONFIG_I: Configured from console by console
Kalimantan#copy running start
Destination filename [startup-config]?
Building configuration...

12. [OK]
Kalimantan#