This document discusses calculating the hydrostatic force on a circular plate submerged in water. It sets up the problem by assuming the plate has a radius of 2 meters and is submerged 6 meters below the water surface. It then describes setting up an axis system and splitting the plate into horizontal strips to calculate the force on each strip. Through integrating the pressure and area of the strips, the total hydrostatic force on the circular plate is found to be 288pi Newtons.

1. APPLICATIONS OF INTEGRALS
POLITICS ( THE CONSTRUCTION OF SUBMARINE)
In this section we are going to submerge a vertical plate in water and we want to know the
force that is exerted on the plate due to the pressure of the water. This force is often called the
hydrostatic force.
Find the hydrostatic force on a circular plate of radius 2 that is submerged 6 meters in the water.
Solution
First, we’re going to assume that the top of the circular plate is 6 meters under the water. Next,
we will set up the axis system so that the origin of the axis system is at the center of the plate.
Setting the axis system up in this way will greatly simplify our work.
Finally, we will again split up the plate into n horizontal strips each of width and we’ll choose a
point from each strip. We’ll also assume that the strips are rectangular again to help with the
computations. Here is a sketch of the setup.
The depth below the water surface of each strip is,
and that in turn gives us the pressure on the strip,

2. The area of each strip is,
The hydrostatic force on each strip is,
The total force on the plate is,
To do this integral we’ll need to split it up into two integrals.
The first integral requires the trig substitution and the second integral needs the substitution .
After using these substitution we get,
Note that after the substitution we know the second integral will be zero because the upper and
lower limit is the same.