The document outlines the project objectives of building a network model for an oil gathering manifold in an oil field using Pipesim software. It details the steps taken to develop the model, including building well models, pressure/temperature profiles, and inserting ESP performance curves. The conclusion confirms that the model successfully matches field data and is reliable for production optimization analysis.

1. Prepared by:
Mustafa Abdolmotaleb
1

2. Agenda
 Project Objectives
 Steps of building pipesim network model
 Building well models
 Pressure temperature profile
 Inserting ESP performance curve
 Modeling Multi-Zones well (3 Zones)
 Constructing the Network Model
 Displaying the results
 Conclusion
2

3. Project Objectives
 To build a representative network model for one
OGM(Oil Gathering Manifold) in H Field consists of
4 wells using PIPESIM software.
 To match the network model with the field data.
 To display & analyze the results after building the
model.
3

4. Steps of building pipesim network model
Interpretation of results
Run model
Define boundary conditions
Select flow correlation
Make single branch model
Build and connect network model
Set fluid data for black oil
Units
Select pipes in model
4

5. Building well models
5

6. Pressure/Temperature Profile
6

7. Inserting ESP Performance Curves
7

8. Modeling Multi-Zones well (3 Zones)
Black Oil Model
8

9. Pressure/Temperature Profile
9

10. Constructing the Network Model
10

11. Displaying the results
11

12. Displaying the results
12

13. Conclusion
 The model has been matched with the real field data.
 The model is now reliable for further production
optimization analysis.
 All the pressure/Temperature profiles for all the wells
have been calculated from the reservoir to the delivery
point.
13