This is a nanotechnology is a South African product for diesel /petrol engines. 1. Engines last longer, runs cheaper, cooler, smoother and substantially reduced soot and odour. 2. Cost savings 10 to15% ( transport )and up to 28% on generators. 3. Use 3ml naftech to 1L fuel (300ml to 100L diesel ) 4. Less GHG ( green house gas ) emissions. 5. Tested by CSIR and SABS approved (SANS 324 for diesel and SANS 1598 for petrol) Naftech serves on the board of ASTM ( American Society for Testing Materials ) witch sets the international petroleum standards in 53 countries world wide. Mechanical engineers are in the team for technical assistance.

1. Diesel Analysis Report
PASS
Percent Bio Diesel
0 ml free water in sample
SAMPLE NO BS27569 06
Company Name: Clean Living Technologies
Work Phone:
Fax Number:
Email Address: johann@cleanliving.co.za
Description Bulk Tank
Site Shell Pretoria
Sample Volume 1000
Sampling Date 2011/10/18
Date sample received 2011/10/18
Test Date (Sample) 2011/10/18
Density @ 20°C 0.8255
Viscosity @ 40°C 3.0
Sulphur Content 17
Total Acid Number
IBP 172
10 207
20 229
30 246
40 261
50 276
60 289
70 306
80 326
90 354
FBP 378
% Re 97.7
% Residue 1.8
The sample supplied conforms with SANS specification (SANS 342:2006)
with respect to the tests performed.
Contact: Johan Pienaar
Type of Fuel Container WearCheck Fuel Container
TESTS DONE RESULTS UNITS SANS 342 (2006) SPECIFICATIONS
90% Recovery Temperature 354
Total Contamination 10.4
Calculated Cetane Index 56.2
VISUAL INSPECTIONS ADDITIONAL TESTS
DISTILLATION AND GRAPH IMAGE OF DEBRIS
DIAGNOSTIC INTERPRETATION AND OPINION:
Kg/L
cSt
°C
%
°C
mg/kg
ppm
%
0.800min
2.2 - 5.3
55 min.
0.05 max.
362 max.
24 max.
500 max.
PASS Density is within the SANS specifications
PASS
Visible Water: None Observed
Colour of Fuel: Straw Yellow
Appearance: Clear
Bacteria Not Requested
Normal distillation - no dehydration of sample was required
Water Content 0.00
°C
°C
°C
°C
°C
°C
°C
°C
°C
°C
°C
Flashpoint 69 PASS
PASS
PASS
ml
PASS
PASS
Viscosity is within specification
Flashpoint is within specifications.
Water content is within specification
The 90% Rec. Temp. is within specification
Total Contamination is within spec.
Sulphur Content is within specification
Issued subject to Standard Conditions (avaliable on request) - NOTE: Sample results are based on the sample RECEIVED.
Chassis number:
Vehicle Registration no:
SAMPLE CONFORMITY YES
%
100
150
200
250
300
350
400
10 20 30 40 50 60 70 80 90 FBP
WEARCHECK AFRICA IS A REGISTERED ISO 9001 AND ISO 14001 COMPANY2011/10/19 Page 1 of 1
WearCheck Africa, Set Point Building, 30 Electron Rd, Isando, 1630
The test report shall not be reproduced except in full, without written approval of the laboratory
Tel: (031) 700-5460 / (011) 392-6322, Fax: (031) 700-5471 / (011) 392-6350 or Email: support@wearcheck.co.za