ppt about adc

1. Direct vs Integrated ADC Differences
Direct Type Integrated Type
A/D Conversion is in a direct manner A/D Conversion is in a indirect manner.
Input analog voltage is directly
compared with the internally generated
equivalent signal and converts the same
into digital code.
Input analog voltage is converted into a
linear function of time or frequency and
converts the same into digital code.
Eg: Flash (comparator) type ADC,
Counter type ADC, Tracking or Servo
operated
ADC and Successive approximation ADC.
Eg: Charge balancing type ADC and dual
slope ADC.

2. Flash ADC
Simultaneous ADC
Parallel Comparator ADC

3. Condition Comparator Output
Vi > Vref V0 = 1
Vi < Vref V0 = 0

4. Flash ADC Truth Table

5. Pros and Cons
• Advantages:
• Flash ADC is the fastest because A/D conversion is performed simultaneously
through a set of comparators. Typical conversion time is 100 ns or less.
• The construction is simple and easier to design.
• Disadvantages:
• This is not suitable for A/D conversion with more than 3 or 4 digital output
bits. It is because of the fact that (2n – 1) comparators are required for an n-bit
ADC and the number of comparators required doubles for each added bit.

6. Dual Slope ADC

7. Functional Block Diagram

8. Description
• Consists of a
1. high impedance buffer (voltage follower), A1
2. integrator, A2
3. voltage comparator (CMP)
• If there is no START command, SW1 is connected to ‘gnd’ and SW2 is
closed. Now CAZ is used to provide compensation for the offset
voltage of all three op-amps.
• If START command is issued, SW2 is connected to ‘gnd’ and SW1 is
connected to Va
.

9. Description
• At time, t1:
• SW1 is connects Va to A1. SW2 is grounded.
• n-stage counter starts counting from ‘0’ and it resets after
2n clock cycles.
• Va is integrated by the integrator until counter is resetted
(i.e) for a fixed duration of 2n clock periods.
• For an integrator, if the input is a positive step; then the
output is a negative ramp. So, a negative ramp is obtained
across output (V0).

10. Description
• At time, t2:
• n-stage counter is resetted.
• SW1 connects VR to A1. SW2 is grounded.
• Counter again starts counting from ‘0’.
• VR is integrated by the integrator (a positive ramp is
obtained as VR is positive) until the output voltage (V0) is
zero.

11. Description
• At time, t3:
• V0 will become ‘0’.
• Now the counter value at t3 , say ‘N’, is proportional to the
analog input voltage, Va.
• EOC is issued by the converter.

12. Output Waveform

13. Derivation of V0
• See Notes

14. Inferences:
• N is directly proportional to Va.
• Provides excellent noise rejection.
• Needs long conversion time.
• Used for accurate measurement of slow varying (less frequency)
signals.

15. Problem: