This document provides instructions for building a DIY microscope from laser-cut parts and a webcam. The summary is: 1. The instructions guide the reader through each step to assemble the microscope parts, including unsoldering an LED from the webcam, stripping and soldering wires, assembling the slider mechanism, and securing the webcam and lens in place. 2. Tools needed include a soldering iron, tin remover, screwdriver, pliers, and stripping pliers. 3. Once fully assembled, the DIY microscope can be used with the webcam to view samples through the upside-down mounted lens.

1. Bouw je eigen microscoop
Xiamyra Daal

2. Xiamyra
(shamira)
Biomedische
Wetenschappen
- microscopie! -
Kennis voor
iedereen
Maker / DIY
Vernieuwing

3. Waag Society

4. De nieuwe technologie: Het internet
‘..een soort stad; een soort Almere in de computer: het is
geen Amsterdam, want het is gloednieuw, maar er wonen
wel veel Amsterdammers.’
smouter.net
trouw

5. Waag DNA
Wetenschap Maatschappij
Kennis voor iedereen
Learning by doingUsers as designers

6. FabLab Amsterdam

7. Fabschool kids

8. Fabschoolino
25,-
fabschoolino.waag.org

9. WetLab

10. WetLab: Do-It-Together Bios

11. WetLab: Projectdagen

12. WetLab: BioHack Academy

13. BioHack Academy - Open Source

14. BioHack Teacher bootcamp

15. BioHack Teacher Bootcamp Week
24 - 28 juli 2017
Meld je
nu aan!

16. Aan de slag!
• 2-tallen
• 45 min. bouwen
• 10 min. nabespreking
• 2-tallen
• 45 min. bouwen
• 10 min. nabespreking

17. Components
• Laser cut parts
• Webcam
• 1x 10mm bolt
• 2x 16mm bolt
• 3x M3 nut

18. Tools
1. Soldering iron
2. Tin remover
3. Screw driver
4. Pliers
5. Stripping pliers
3
2
1
4
5

19. Test your webcam
The LEDs should work

20. Unscrew the shell of the webcam

21. Remove the lens

22. Careful: do not touch the sensor!

23. Carefully unsolder 1 LED
It may help when your colleague pulls the LED out

24. How to solder?

25. Carefully unsolder 1 LED
It may help when your colleague pulls the LED out

26. Strip and solder the wires

27. Test how to resolder the LED to
the PCB

28. Remove the lens holder

29. Assemble the slider
Place the slider in the two elements with a sliding rail

30. Attach the camera plate
It locks all four vertical elements in place

31. Seal the slider
Secure the slider in place by adding the two outer elements

32. Get the camera through the hole
Make sure the USB cable sticks out to the back

33. Secure the camera in place
Place the two elements on both sides
Place the lens mount

34. Mount the lens upside down

35. Assemble the side panels and put the lid on

36. Add the supports to the stage

37. Put the stage in place and secure it
Check the orientation
make sure the screw hole is in the right place

38. Put the lid in place… DONE!

39. Fotospectrometer

40. Benodigdheden

41. DIY preparaten maken

42. DIY preparaten maken

43. DIY preparaten maken