The document describes the various steps taken to construct and prepare a rocket for launch. It details gluing bulkheads and fins into sections, inserting components like altimeters and parachutes, reloading the engine by adding delays and O-rings, drilling holes, tying off parachutes, and packaging the final payload. A completed rocket is shown at the end, with all components assembled and ready for flight.

2. Cutting fins with the ban-saw

3. Just finished gluing in the bulkhead
in the altimeter section of the rocket

4. Inserting the altimeter tube and
mounting ring

5. Gluing in the bulkhead for the bottom of
the payload section

6. Letting the glue set for the first fin

7. Measuring the distance between the
three fins

8. Gluing the second fin on the rocket

9. Setting out the components for the
engine reload

10. Placing the delay and O-rings in the top
portion of the engine

11. The engine reload is complete

12. Drilling a hole for the shock cord to the
airframe parachute

13. Tying off the parachute to the
altimeter/payload section

14. Finally, gluing the last fin on the
rocket

15. Packaging the eggs for the
payload section

16. All the final
components of
the rocket

17. The final product!!!