2. The first thing that I done was use the ‘Unsharp Mask Tool’ to make sure that the picture is clear and has better
quality. This also will remove any blur that is in the image which is good because I want the audience to be
attracted to the main screen and the people standing on the main stage due to the fact that they were the main
attraction at the event.
3. Then I used the ‘Brush Tool’ and outlined the main screen because I want the main screen to be lit up due to the
fact that it is one of the main attractions. Then I turned down the ‘Opacity’ to about ‘6%’ because I only wanted
the outline of the main screen to be lit up and I didn't want the massive white lines to be visible.
4. Then I cropped the image to make sure you cant see the unwanted things in the image, for example there is a
phone that is on in the photo so I wanted to remove that because it might of put the audience off the main stage.
So I zoomed in a little bit and made sure that the main focus is on the screen and the people standing underneath
it.
5. After cropping the image, I used the ‘Curves Tool’ because I wanted to make sure that the picture had enough light
in to make the main screen and the people standing underneath it the main attraction of the image.
6. Finally I used the ‘Hue/Saturation Tool’ because I wanted to turn the ‘Saturation’ up to make sure the image has
enough colours and that so the main screen and the people standing underneath it are standing out.
