2. 1
About Author
I am Shobhit Verma, I am dedicating this book to those person who is start our career in computer as a
computer operator. I’ll try to do my best. I’ll be launch a lots of books related to computer with image
practical.
Like :-) Operating system, Networking, Server, Basic CMD etc
It’s a brief description about this book.
Thank you
3. 2
In this book I’ll be teach you that how create a bootable pen drive using Command ………..
Let’s Start -:
There are some steps are given bellow :-
1. Open you computer.
4. 2. After that open the My Computer. Before inserting pen drive My Computer window some look like
this as given in Figure
1.
3
5. 3. Take A Pen Drive then insert Your System then my Computer Window look like this
As given in Figure :- 1.2
6. 4
4. Open run panel using short cut keys- window key+ R
As given in Figure :- 1.3
7. 5
5. Then type “CMD” and hit enter AS Given in Figure :- 1.4
8. 6
6. Then auto open a window look like this .
Figure :- 1.5
9. 7
Now write a command in given display “ diskpart ” then hit enter as given in Figure :- 1.6
After that a prompt came in your display give it permission yes……..
Then came a new window in front of you
10. 8
After given permission :-
Write a new command “ list disk “ and hit enter :-
As given in figure 1.7 :-
11. 8
After writing this command you will see in panel that it’s shows two disk
1st
is your hard disk (disk 0)
2nd
is your pendrive (disk 1)
As shows in figure 1.8 :-
12. 9
Now turn to select your select your pen drive so write this command
“ select disk 1 “ hit enter
As shown in figure :-
Now your display look like this :-
13. 10
Now turn to clean the pen drive so write the command
“ clean “ hit enter
As shows in Figure :-
14. 10
Now create a primary partition so write the command
“ create partition primary “ hit enter
As shows in figure :-
15. 11
Now turn to select the partition using this command
“ select partition 1 “ hit enter
As shows in figure :-
16. 12
After that active the partition which we are selected write this command :-
“ active “ hit enter
As shows in figure :-
17. 13
Now turn to make a bootable pen drive using this command :-
“ format fs=fat32 quick “ hit enter
As shown in figure :-
18. 14
Now we again active the format Pen Drive , write this command :-
“ active “ hit enter
As shown in figure :-
19. 15
Now exit the window using the command :-
“ exit “ hit enter
As shows in Figure :-
20. 16
Then again exit 1st
window of command :-
“exit” hit enter
As show in Figure :-
25. A lot of book
is pending for
your learning –
Like :- Hacking Book,
How to format a pen drive when pen drive is
not format able.
Server Book, Networking Book,
26. C & C++ Programming Book and many
more.
Thank You
Shobhit Verma