Report on topic presentation (format)2015 by amit kumar

1. Report on topicpresentation of-IC ENGINE
1
TOPIC PRESENTSTION ON
IC (INTERNAL COMBUSTION) ENGINE
Submitted by:
Amit Kumar
(ME/15/722)
Department of Mechanical Engineering
SHRI BALAWANT INSTITUTE OF TECHNOLOGY
Approved by AICTE, Min of HRD, Gov of India & DTE, Govt of Haryana
Affiliated to DCR University of Science and Technology, Murthal, Sonepat
Meeru Road (Pallri), Near DPS, Sonepat-131001, Haryana

2. Report on topicpresentation of-IC ENGINE
2
Abstract:-
This is the report of topic presentation of IC (INTERNAL COMBUSTION) ENGINE ,in this report I’m
introduce IC Engine and its various parts in short ,and I also explain the mechanism of IC Engine to start and do
work ,in this report we also tell how many type of IC Engine according By number of strokes, By type of
ignition, By mechanical/thermodynamical cycle ,Rotary, Continuous combustion, The jet engine types, and I
also explain Two-stroke engine, Four-stroke engine (Otto cycle),Six-stroke engine & respective diagram of
Two -stroke engine, Four-stroke engine(Otto cycle), in this section we also know about Crankcase scavenged
Blower scavenged, Diesel Ignition Process, Lubrication, Cylinder configuration, Diesel cycle, Combustion
turbines, Gas turbines, Jet engine, Brayton cycle.

3. Report on topicpresentation of-IC ENGINE
3
CERTIFICATE
This is to certify that the topic presentation entitled as IC (INTERNAL COMBUSTION) ENGINE and
submitted by AMIT KUMAR having Roll No ME/15/722, embodies the bonafide work done by him under my
supervision. His conduct and behavior is satisfactory.
Signature of the Supervision
Place: SBIT , SONEPAT
Date :

4. Report on topicpresentation of-IC ENGINE
4
TABLE OF CONTENTS
1. INTRODUCTION ……………………………………………………………………………………......5
2. DESCRIPTION………………………………………………………………………………….….….....6
3. CONCLUSION…………………………………………………..……………..…………………….…...7
4. REFERENCES………………………………………………………………….…………………….......8

5. Report on topicpresentation of-IC ENGINE
5
INTRODUCTION

6. Report on topicpresentation of-IC ENGINE
6
DESCRIPTION

7. Report on topicpresentation of-IC ENGINE
7
CONCLUSION
After this section I conclude that
 Where very high power-to-weight ratios are required, internal combustion engines appear in the form
of combustion turbines. Powered aircraft typically uses an ICE which may be a reciprocating engine.
Airplanes can instead use jet engines and helicopters can instead employ turboshafts; both of which are
types of turbines. In addition to providing propulsion, airliners employ a separate ICE as an auxiliary power
unit.
 Reciprocating piston engines are by far the most common power source for land and water vehicles,
including automobiles, motorcycles, ships and to a lesser extent, locomotives (some are electrical but most
use Diesel engines. Wankel engines are used in some automobiles and motorcycles.
 Most truck and automotive diesel engines use a cycle reminiscent of a four-stroke cycle, but with a
compression heating ignition system, rather than needing a separate ignition system. This variation is called
the diesel cycle. In the diesel cycle, diesel fuel is injected directly into the cylinder so that combustion
occurs at constant pressure, as the piston moves.
 Otto cycle is the typical cycle for most of the cars internal combustion engines that work using gasoline as a
fuel. Otto cycle is exactly the same one that was described for the four-stroke engine. It consists of the same
four major steps: Intake, compression, ignition and exhaust.
 PV diagram for Otto cycle On the PV-diagram, 1–2: Intake: suction stroke 2–3: Isentropic Compression
stroke 3–4: Heat addition stroke 4–5: Exhaust stroke (Isentropic expansion) 5–2: Heat rejection the distance
between points 1–2 is the stroke of the engine. By dividing V2/V1, we get: r, where r is called the
compression ratio of the engine

8. Report on topicpresentation of-IC ENGINE
8
REFRENCES
www.icengine.com
www.machenicalengineeringtechonology.com
www.icengineparts.com
Elements of Mechanical Engineering (Book)