internal architecture and pin configuration

1. Internal Architecture And
Pin configuration of 8085
Microprocessor
Prepared By:-
Shraddha Aron
(1401421065)
EN-1

2. CONTENTS
• Microprocessor
• Internal architecture of 8085
microprocessor
• Register structure
• 8085 pin configuration
• Address Bus
• Control and Status signals
2MICROPROCESSOR

3. CONTENTS
MICROPROCESSOR
• Power supply and clock frequency
• Externally initiated signals and
interrupts
• Serial I/O Port
3

4. MICROPROCESSOR
With the advancement of
microelectronics technology, it become
possible to integrate ALU, control
circuits & memory on a single silicon
chip. This IC chip is called
microprocessor.
MICROPROCESSOR 4

5. MICROPROCESSOR 5

6. 8085
MICROPROCESS-
OR

7. • The 8085 is an 8-bit general purpose
microprocessor that can address
216
=64K Byte of memory.
• It has 40 pins and uses +5V for power.
It can run at a maximum frequency of
3 MHz.
MICROPROCESSOR 7

8. INTERNAL
ARCHITECTURE
MICROPROCESSOR 8

9. MICROPROCESSOR 9

10. It consists of various functional
blocks as listed below –
• Registers
• Arithmatic and Logic Unit
• Instruction Decoder & Machine cycle
encoder
• Address Buffer
• Address/Data Buffer
• Incrementer/Decrementer Address
Latch MICROPROCESSOR 10

11. • Interrupt Control
• Serial I/O Control
• Timing & Control circuitary
MICROPROCESSOR 11

12. REGISTER STRUCTURE
MICROPROCESSOR 12

13. 8085 registers are classified as-
General Purpose registers
Temporary registers
1. Temporary data register
2. W & Z registers
Sixteen bit registers
1. Program Counter
2. Stack Pointer
MICROPROCESSOR 13

14. Special Purpose registers
1. Accumulator
2. Instruction register
3. Flag registers
MICROPROCESSOR 14

15. MICROPROCESSOR
8085 PIN
CONFIGURATION
15

16. MICROPROCESSOR 16

17. MICROPROCESSOR 17

18. ADDRESS BUS
8085 has 16 signal lines that are used as
address bus; however, these lines are
split into two segments: and
MICROPROCESSOR
815 AA −
07 ADAD −
18

19. CONTROL & STATUS
SIGNALS
MICROPROCESSOR
This gp. of signals includes two control
signals ( and ), three status
signals(IO/ , and ) to identify the
nature of the operation and one special
signal (ALE) to indicate the beginning of
the operation.
RD WR
0S
M 1S 0S
19

20. POWER SUPPLY AND
CLOCK FREQUENCY
The power supply and frequency signals
are as follows :-



CLK(OUT)
MICROPROCESSOR
CCV
SSV
21andXX
20

21. EXTERNALLY INITIATED
SIGNALS AND INTERRUPTS
 INTR

 RST 7.5, RST6.5, RST 5.5
 TRAP
 HOLD
 HLDA
 READY
MICROPROCESSOR
INTA
21

22. 
RESET OUT
MICROPROCESSOR
RESETIN
22

23. SERIAL I/O PORT
8085 has two signals to implement the
serial transmission: SID and SOD
MICROPROCESSOR 23

24. THANK YOU…
ANY QUERIES
?..
MICROPROCESSOR 24