1. Cutting the starfish’s drawer sides<br />-38100139065<br />The Date: 15. Feb. 2011<br />What you did: Today I cut the pinewoods to make my product’s drawer sides. I cut it 5 pieces of pinewoods, and started marking angles on the pinewoods, so that I can stick them together later when I finished all works. And after I finished marking angles on the pinewoods, I started cut them to angles.<br />-243967092075Changes to your plan: I don’t have to change my plan, because I still have time to finish cutting the drawer sides. But if I finish cutting the drawer sides I’d better start on glue them together.<br />-2437130795655Emotions: Today, while cutting the pinewoods to 5 pieces, it was little bit hard, and my shoulder feel hurt. The reasons why I feel hard and my shoulder was hurt were because the pinewoods are really thick so I have to cut it. And while cutting the pinewoods, I have to use my shoulder to cut the thick pinewoods. I have to cut lots of times, so it was hurt than before.<br />What’s next: After finish cutting the pinewoods to angles, I have to check that the pinewoods are fitting together and stick them together.<br />Area of Interaction and Learner Profile: I think I was a Well-balanced while cutting the pinewoods to make my product’s drawer sides and make angles to them.<br />Why: The reason why I think I was a Well-balanced while cutting the pinewoods to make my product’s drawer sides and make angles to them were because I have to use power at my shoulder, so I think I have exercised to make my shoulder stronger.<br />Tools: Tenon saws, Pinewood, Tri Square, Pencil, Eraser<br />