1. Check sides and sanding before glueing them<br />080010254001959610254003788410The date: Feb.22.2011<br />What you did: Today, I check the sides before stick them all together. And I have to sand the sides because I have to make them fit together accurately. It was little bit-tired job, because I have to check all of the pieces that I am going to use for my product’s side. If one piece of plywood is not fit, I have to make a new again.<br />Changes to your plan: I am making my product than I have thought. So there are no changes to change my plan. So I don’t have to change my plan.<br />Emotions: It was really tired while checking the all of the plywood that I am going to use for my product’s sides. The reason why I was tired is because I have to check all of them and sand them accurately. If I don’t check and sand them accurately, I have to make a new again.<br />What’s next: After check and stick them all, I have to cut the top of my product. It will be a hard job to cut the top of my product. So I think I have to concentrate while cutting the top of my product.<br />Area of Interaction and Learner Profile: I was well balanced while finish check the all of the plywood that I am going to use for my product’s sides.<br />Why: The reason why I think I was well balanced while finish checking the all of the plywood that I am going to use for my product’s sides is because I have finished checking them and sanding them also in class time. <br />Tools: Plywood, Pencil, Eraser, Tri square, Desk sander and Goggle<br />