1. -457200-228600Cutting the Starfish Drawer Sides<br />Date: 11th. February. 2011<br />-2171700704850What you did: Today I did some trimming the plywood, drawing lines and cutting the pinewood. I sanded the plywood to make my product’s sides. And today, I finally finished sanding. So I started to cut the pinewood to make my product’s drawer sides. Before cutting the pinewood, I started to draw lines to a size that is same as the sides of my product’s sides.<br />Changes to your plan: This week, I should finish up sanding and should start on measuring and the mark out the pinewood to make my product’s drawer sides. And today, I achieved these goals, so I started on cutting the pinewood.<br />-2171700844550Emotions: Today while working on my product, I feel satisfied. Why I fell satisfied was because I have achieved my goal that I have to do until this week. While sanding the plywood, it was really hard job to sand accurately, but finally I sanded accurately. So I started on measuring and mark out the drawer sides. <br />What’s next: After finish measuring and mark out the drawer sides, I have to start on cutting the drawer sides. If I finish cutting the drawer sides, I have to check that the sizes are accurate.<br />Area of Interaction and Learner Profile: Today, I think I was a Thinker while measuring and marking out the drawer sides.<br />Why: The reason why I think I was Thinker was because I have lots of thinking and had to consider many different aspects of construction and making to make sure I was doing the right process. While measuring and mark out the pinewood to make my product’s drawer sides.<br />Tools: Sanding saw, Tenon saw, Bench hook, Pencil, Ruler, Pinewood, and Plywood<br />