2. Materials needed :
2 the same plastic boxes
16 wood screws
4 pieces of wood 5x5x20 cm
2 boards 60 cm long
2 boards 70 cm long
1 m of rope
Some beans
Some adhesive tape
Wooden knob on a stick
3. Assembly :
BOXES
Open boxes.
Drill two holes on opposite sides of the box.
Stick 30 cm of rope in the box and tie a knot on
one end. Do the same thing on the other side.
Repeat the action with the second box.
Put some beans to both boxes.
Close the boxes and secure them with adhesive
tape so the beans will not fall out.
4. THE FRAME
Two boards ( 60 cm i 70 cm ) and one piece of wood,
connect with the screws so they make letter „L”.
Do the same with the other two.
Put both parts together.
In the middle of the top board make a hole for the nob.
Make two smaller holes (for the rope holding the boxes)
on bothe sides of the big hole ( the same distance).
Drill the same small holes (for the ropes) in the bottom
board.
5. Finishing:
Put the knob through the big hole and secure
with the adhesive tape.
Put the ropes from the boxes through the
smaller holes on the top and the bottom of the
frame.
Stretch the ropes and tie strong knots.
Your machine is ready
You can paint it with your design.
READY !
