Menjelaskan tentang merakit komputer dengan baik dan benar

1. Aditya
Wicaksono
IKS-01
How to assemble
a
computer

2. Installation PC
Before assembling a PC we must prepare the tools and materials
Screwdriver Plus (+) & (-)
Cutting pliers
Multitester
Toools
InstallationPC

3. Materials
Motherboard VGA Card Processor RAM
Harddisk
Heatsink
Power
Supply
DVD
Mouse &
Keyboard
Monitors
Cassing
InstallationPC

4. Step-by-step assembly
1. Laying flat motherboard in place and do
not forget to give the base with a soft
surface so that the motherboard is not
scratched or broken path components.
2.Install the processor on the motherboard.
Installation processor earned outside the
casing to facilitate you in the installation of
the processor. Installation processor
adapted to the type of processor and
motherboard used.
InstallationPC

5. 3.Once the processor is installed and then
perform the installation of the processor
fan.
4.Install the RAM on the RAM slot
available on the motherboard. Installation
of RAM in slots must follow the rules
because if there is an error in the
installation can make the RAM and
motherboard is damaged or frayed.
InstallationPC

6. 5.Prepare the chassis for installation of all
components that have been provided.
After preparing the casing attach the power
supply or power supply
6.Then enter the motherboard to the
chassis slowly so that the motherboard is
not damaged. At the time of installation of
the motherboard, note connector mouse,
keyboard, serial, VGA and sound so that
the panels are installed on the casing
properly.
Then make a motherboard with the stand
so strong and not rocking.
InstallationPC

7. 7.Install the VGA card in the slot available
on the motherboard vga. Installation vga
slot should follow the rules because if there
is an error in the installation can make a
vga and the motherboard is damaged or
frayed.
8. After the install CD ROM on the shelf
contained in the casing, by entering from
the front. Then bautlah CD ROM that was
installed earlier invitation shelves so as not
to jiggle. Then plug in the power cable and
data cable or cables ATA CD-ROM on the
motherboard.
InstallationPC

8. 9.Install a hard drive on the shelf contained
in the casing by gently so as not to hit the
hard disk. Then bolt securely to prevent
rocking. Once the hard drive is installed
and then plug the data cable or ATA hard
drive cable to the motherboard and the
hard disk itself
10.Connect the power supply in place
contained in the motherboard. If the
installation is wrong it will cause fatal
damage to the motherboard.
InstallationPC

9. 11.Then plug the power connector / restart
/ hdd lad / power lad and other connector
pad located on the motherboard
12.Once all the components have been
installed and attach the chassis cover
properly
InstallationPC

10. 13.Completed then the assembly should we test whether
successful or not. Attach the monitor to the VGA port cable then
the monitor and CPU power to the electrical switch, then turn it on
when the computer can boot the managed assembly.
Pc Installation Success
InstallationPC