45-degree-left-and-right-moment-durability-test-rig-ppt.pptx

3. 45 Left and Right Movement Durability Test Rig.
The Scope of Test Rig development involves the following:
 Automatic adjustment of Base Frame Height Depending on the UUT through Static
Load Hydraulic Actuator (Travel up to 300 mm).
 Application of 300 -350 Newton Hydraulic Load at an angle of 450 to the UUT at
20 CPM (This can be adjusted between 0-20 CPM)
 Load Application Cycle to be applied is
Step i: Load on Left
Step ii: Load on Right
 Dynamic Hydraulic Actuator Selection Should be for 150 mm Travel and it should
be capable of applying up to 5000 Newton Load
 Measurement of Load applied (load Cell of 5 kN capacity)
 Display, Storage and Report Generation of the Data

5.  SS 304 Tank-150 liters with necessary fittings & mountings, Drain
Valve (Audco).
 Level Switch, level Gauge, temperature Switch, Filler Breather.
 Parker Make Pump/ Motor System with Couplings/ Mountings &
Frame
 Pressure Regulator, Tescom/ Parker Make
 Flow Control Valve

7. Items Description
24 Volts DC Power supply 5 amp (DR-120-24)
LED 24 volts DC(Red) 24 V DC
LED 24 volts DC(Green) 24 V DC
Contactor 9 amp, 24 volt(coil)
Thermal OLR 2-5 Amp
Terminal for Power (thick
wire)
UK-10
MCB TP, 6 Amp
MCB DP, 6 Amp
Green Terminal (GND) UK-2.5
Terminal (Neutral) UK-2.5
Red Terminal UK-2.5
Black Terminal UK-2.5
relay 24 volts DC, 6 amp.

8. Application of 300 -350 Newton Hydraulic Load at an
angle of 450 to the UUT at 20 CPM (This can be
adjusted between 0-20 CPM). Dynamic Hydraulic
Actuator Selection Should be for 150 mm Travel and it
should be capable of applying up to 5000 Newton
Load. Measurement of Load applied (load Cell of 5 kN
capacity).

9. Thank You