This document discusses suturing materials and techniques used in dentistry. It begins with an introduction to sutures and their purpose in closing wounds. It then covers general suturing principles, features of ideal suture materials, sizes of sutures, classifications of suture materials including absorbable and non-absorbable types. The document also discusses surgical needles, knots, and various suturing techniques including interrupted, continuous, mattress, and sling sutures. It emphasizes selecting the appropriate suture size and material for the wound and tissue being closed. In conclusion, it states that knowledge of suturing is important for surgical procedures and innovation in materials can decrease infections.
2. CONTENTS
⢠Introduction
⢠General principles
⢠Features of ideal suture material
⢠Size of suture material
⢠Classification of suturing material
⢠Surgical needles
⢠Knots and types
⢠Types of suturing
⢠Conclusion
⢠References
3. Introduction
⢠Sutures are tiny threads,wire or other material
used to sew body tissue and skin together.They
may be placed deep in the tissues or superficially
to close a wound.(Perry et al 2014)
⢠The primary objective of suturing is to position
and secure surgical flaps to prompt optimal
healing without any tension in that area.(Ulin AW
et al 1975)
⢠Sutures are maintained in the desired position
until healing has progressed to the point at which
sutures are no longer needed.
4. General principles
⢠Grasp the needle 2/3 front and 1/3 behind the
needle holder.
⢠The needle should pass perpendicular to the
tissue.
⢠The needle should pass at an equal depth and
distance on both sides of the wound.
5. ⢠Pass the needle from the thinner to the thicker
tissue.
⢠The suture should never be closed under tension.
⢠The knot should be placed 2-3mm from the
incision.
⢠Suture should pass over the dental papilla,and
not the empty socket.
6. ⢠Use few knots as possible.
⢠Use least amount of suture that will secure
the wound.
⢠Use the smallest suture possible to close the
wound.
7. Features of ideal suture material
⢠Should have high tensile strength to hold the
margins approximately till the healing is
complete.
⢠Should not cause any allergic or tissue
inflammation.
⢠Should have least capillarity so that the suture
material does not soak in the inflammed tissue
fluid
8. ⢠Should have good knoting properties.
⢠Should be easily sterilized.
⢠Should be visible in the surgical field.
⢠Should be resonablly inexpensive.
9. Size of suture material
⢠Suture materials are available in various sizes
depending on its tensile strength.
⢠The standard for identifying varying tensile
strength of a given suture material is determined
by the number of zeros.(Lober CW et al 1986)
⢠The smaller the cross sectional diameter the
more zeros the suture has.
10. ⢠Sizes start with a 0 and progress downward
through 00,000,4-0,10-0.
⢠Thus 4-0 nylon has a greatest diameter than 6-
0 nylon and therefore a greater tensile
strength.
11. Classification of suturing materials
ďBased on number of filaments:
⢠Monofilaments(steel,nylon)
⢠Multifilaments(silk,cotton)
ďBased on suture diameter in descend order
from 5,4,3,2,1-0 till 11-0 size.
ďBased on absorbability
⢠Absorbable
⢠Non absorbable
12. Absorbable:
⢠The materials loss their tensile strength within 60
days.They are digested or hydrolysed by the
enzymes present inside the body.
I. Natural
II. Synthetic
Non-absorbable:
⢠These materials cannot be digested by the body
and therefore should be removed by the surgeon
at the end of healling.
I. Natural
II. Mettalic and
III. synthetic
20. Surgical needles
⢠Based on shape
I. Straight
II. Curved
⢠Based on eye
I. Eyed
II. Eyeless
⢠Based on function
I. Cutting
II. tapered
21. knots
⢠Knot is composed of a number of tight
throws,each throws represents a weave of the
two strands and ears that are the cut ends of
the suture.(Meinel L,et al 2005)
⢠Components of knot comprises of
ďLoop
ďKnot
ďears
22. Types of knots:
⢠Sqaure knot-two single tie in opposite direction
⢠Granny knot-two or three tie in the same
direction
⢠Surgeonâs knot(2-1)-the first tie is double and the
second tie is single in opposite direction
⢠Surgeonâs knot(2-2)-the first and second tie are
double in opposite direction.
23.
24. Technique:
⢠The needle is held with the needle holder and it
should enter the tissues at right angles and be no
less than 2-3mm from the incision.
⢠The needle is then carried through the tissue
where it follows the needleâs curvature.
⢠Sutures of any type that are placed in the
interdental papilae should enter and exit the
tissue at a point located below the imaginary line
that forms the base of the triangle of the
interdental papilla.
25. ⢠The location of sutures for the closure of the
palatal flap depends on the extension of the
flap elevation that has been performed.
⢠If the elevation is slight or moderate,the
sutures can be placed in the quadrant closest
to the teeth.
⢠If the elevation is substantial, the sutures
should be placed in the central quadrants of
the palate.
27. ⢠Continuous locking
ď Simple sling suture
ď Periosteal suture
ď Horizontal mattress suture:
⢠It is often used for interproximal areas of diastema or
wide interdental spaces to adapt the interdental
papilla properly against the bone.
⢠Two sutures are often necessary,and the horizontal
mattress suture can be incorporated with the
continuous independent sling sutures.
28. ⢠The penetration of the needle is performed in
such a way that the mesial and distal edges of
the papilla lie against the bone.
⢠The needle enters the outer surface of the
gingiva and crosses the undersurface of the
gingiva horizontally.
⢠The mattress suture should not be close
together at the midpoint of the base of the
papilla.
29. ⢠The needle reappears on the outer surface at
the other base of the papilla and continuous
around the tooth with the sling suture.
30. Vertical mattress
⢠The needle penetrates the outer epithelized
surface of the flap 8-10mm apical to the tip of the
papilla.
⢠It is passed through the under surface of the
flap,emerging again from the tip of the
papilla.Thus a vertical bite of 6-7mm is taken with
the needle.
⢠The needle is passed through the embrassure
where the technique is repeated with adjacent
flap.
32. Direct suture
⢠The needle penetrates the outer surface of
the first flap.The under surface of the opposite
flap is engaged and the suture is brought back
to the initial side where the knot is tied.
⢠These sutures are used when bone graft are
placed and when closed opposition of
scalloped incision is required.
34. ďFigure of eight:
⢠The needle penetrates the outer surface of
the first flap and the outer surface of the
opposite flap.
⢠The suture is brought back to the first flap and
the knot is tied.
⢠These sutures are placed when flaps are not in
close apposition because of apical flap
position or non scalloped incisions.
36. ďContinuous independent sling suture:
⢠A sling suture is used when both a facial flap
and a lingual flap are used and when they
involve many teeth.(Carranza,12th ed)
⢠The continuous,independent sling suture is
initiated on the facial papilla closest to the
midline,because this is the easiest place to
position the final knot.
37. ⢠A continuous sling suture is laced for each
papilla on the facial surface.
⢠When the last tooth is reached,the suture is
anchored around it to prevent any pulling of
the facial sutures,when the lingual flap is
sutured around the teeth in a similar manner.
⢠The suture is again anchored around the last
tooth before tying the final knot.
38. ⢠The facial and lingual flap are completely
independent of each other because of the
anchoring around both the initial and final
tooth.
⢠It is especially appropriate for the maxillary
arch because the palatal gingiva is attached
and fibrous,whereas the facial tissue is thinner
and mobile.
40. ďAnchor suture:
⢠The closing of a flap mesial and distal to a
tooth,as in the mesial or distal wedge procedure,
is best accompained by the anchor suture.
⢠This suture closes the facial and lingual flap and
adapts them tightly against the tooth.
⢠The needle is placed at the line angle area of the
facial or lingual flap adjacent to the tooth,
anchored around the tooth passed beneath the
opposite flap and tied.It can be repeated for each
area that require it.
42. ďClosed anchor suture:
⢠Itâs an another technique
to close a flap located in
an edentulous area mesial
or distal to a tooth .
⢠It consists of tying a direct
suture that closes the
proximal flap,carrying one
of threads around the
tooth to anchor the tissue
against the tooth,and then
tying the two threads.
43. ďPeriosteal suture:
⢠The periosteal suture is used to hold the
apically displaced partial thickness flaps on
the periosteum.
⢠There are two types of periosteal sutures: the
holding suture and closing suture.(Verbist
G,et al 2007)
⢠The holding suture is the horizontal mattress
suture placed at the base of the displaced flap
to secure it into the new position.
45. Conclusion
⢠Due to daily surgical procedures carried out by
dentist,a greater knowledge of suturing
armantarium and materials is needed.
⢠The success of technique sensitive surgeries
depends on the clinicians knowledge and skills
to close the wound and achieve optimal
healing.(Mohan H et al, 2009)
⢠The innovation in suturing materials decrease
the potential for post operative infections.
46. References
⢠Clinical periodontology â Carranza 12th ed.
⢠Textbook of oral and maxillo facial surgery â S.M.
Balaji.
⢠Suture materials and suture techniques â myele et al
2015.
⢠Basic suture technique for oral mucosa â Griffin et
al,cllinical advances in periodontics 2011
⢠Sutures and suturing techniques in skin closure-Mohan
H et al, Indian J Dermatol Venereol Leprol | July-
August 2009 | Vol 75 | Issue 4