Upcoming SlideShare
×

# Measurement Quiz

3,603 views

Published on

0 Likes
Statistics
Notes
• Full Name
Comment goes here.

Are you sure you want to Yes No
• Be the first to comment

• Be the first to like this

Views
Total views
3,603
On SlideShare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
11
0
Likes
0
Embeds 0
No embeds

No notes for slide

### Measurement Quiz

1. 1. Microscope/ Measurement Lab Quiz 1. What is the total magnification produced by a microscope, using a 10X ocular lens and a 10X objective lens? 10X 20X 100X 1000X 2. Which of the following describes proper microscope care and technique. Be sure to carry the microscope upright, with one hand on the arm and the other under the base. To protect the optics of the microscope, place it down gently and don't drag it across the tabletop. Always begin focusing with the lowest power lens available. Only use the coarse focus knob with the scanning and low power lenses. All the above are examples of correct microscope care and technique. 3. Turning which of the following knobs moves the objective lenses the greatest vertical distance? coarse focus knob fine focus knob 4. Resolution is the ability to see two objects as separate. true false 5. Which objective lens is the longest? scanning lens low power lens high power lens oil immersion lens 6. Which of the following regulates the amount of light passing through the slide specimen on the microscope stage? nosepiece objective lens iris diaphragm lever fine focus knob 7. An increase in magnification causes a decrease in the field of view. a decrease in the working distance.
2. 2. a decrease in the depth of field. all of the above. 8. Working distance is the distance from your house to your job. distance the microscope nosepiece travels using the coarse focus knob. distance from the bottom of the objective lens to the specimen. distance the specimen can travel across the microscope stage. 10. When using the oil immersion lens, you should raise the objective lenses for easy application of an oil droplet to the slide. true false 11. Why must a small object seen through the ocular lens be centered in the field of view, before changing to a higher power objective lens? to prevent damage to the objective lens to compensate for the decrease in resolving power of the lens to prevent its disappearance due to the decrease in the field of view to prevent eyestrain 13. Why is it necessary to adjust the amount of light after changing objective lenses? Higher magnification lenses require more light. Proper lighting is needed to see specimen details. The lens aperture decreases with higher magnification lenses. All of the above. 14. One meter equals 100 cm. 1000 mm. 1,000,000 microns. All of the above. 16. If you prepare a wet mount slide and observe a large empty circle with dark edges, you are most likely seeing an air bubble. true false 18. Depth of field is best demonstrated with a slide showing the letter e. a slide containing overlapping threads. a wet mount slide preparation. the oil immersion lens.
3. 3. 19. When the letter e slide is viewed with the microscope, it appears right side up. right side up and backwards. upside down. upside down and backwards.
4. 4. Graduated Cylinder Objects Volume 1. 2. 3. Metric Ruler Objects Length 4. 5. 6. Triple Beam Balance Objects Mass 7. 8. 9.