The document discusses the multi-stage process of wastewater treatment. It begins with pre-treatment to remove large debris through screening and grit removal. Primary treatment uses sedimentation to separate solids and floatables. Secondary treatment uses biological processes like activated sludge to break down organic matter. Tertiary treatment provides additional filtration, nutrient removal, and disinfection before water is discharged.

2. It Is the process of removing contaminants from wastewater and household sewage, both runoff (effluents) and domestic. These waters are contaminated by several factors: waste, waste, detergents, oils, chemicals, among others. For that reason, it is important to give treatment to recover and not lose it.

3. PRE-TREATMENT: Pre-treatment removes materials that can be easily collected from the raw waste water before they damage or clog the pumps and skimmers of primary treatment clarifiers (trash, tree limbs, leaves, etc.). In the treatment of wastewater can distinguish four stages which include chemical, physical and biological:

4. SCREENING The influent sewage water is screened to remove all large objects like cans, rags, sticks, plastic packets etc. carried in the sewage stream. This is most commonly done with an automated mechanically raked bar screen in modern plants serving large populations, whilst in smaller or less modern plants a manually cleaned screen may be used. GRIT REMOVAL Pre-treatment may include a sand or grit channel or chamber where the velocity of the incoming wastewater is adjusted to allow the settlement of sand, grit, stones, and broken glass.

5. PRIMARY TREATMENT: In the primary sedimentation stage, sewage flows through large tanks, commonly called "primary clarifiers" or "primary sedimentation tanks." The tanks are used to settle sludge while grease and oils rise to the surface and are skimmed off. Primary settling tanks are usually equipped with mechanically driven scrapers that continually drive the collected sludge towards a hopper in the base of the tank where it is pumped to sludge treatment facilities. Grease and oil from the floating material can sometimes be recovered for saponification. The dimensions of the tank should be designed to effect removal of a high percentage of the floatables and sludge. A typical sedimentation tank may remove from 60 to 65 percent of suspended solids, and from 30 to 35 percent of biochemical oxygen demand (BOD) from the sewage.

6. SECUNDARY TREATMENT: Secondary treatment is designed to substantially degrade the biological content of the sewage which are derived from human waste, food waste, soaps and detergent. The majority of municipal plants treat the settled sewage liquor using aerobic biological processes. To be effective, the biota require both oxygen and food to live. The bacteria and protozoa consume biodegradable soluble organic contaminants and bind much of the less soluble fractions into floc.

7. Secondary treatment systems are classified as fixed-film or suspended-growth systems. Fixed-film or attached growth systems include trickling filters and rotating biological contactors, where the biomass grows on media and the sewage passes over its surface. Suspended-growth systems include activated sludge, where the biomass is mixed with the sewage and can be operated in a smaller space than fixed-film systems that treat the same amount of water

8. TERTIARY TREATMENT : Removes the pollutants were not sufficiently removed in secondary treatment ; As solids, nitrogen, phosphorus, and other pollutants such as color and metals. The purpose of tertiary treatment is to provide a final treatment stage to raise the effluent quality before it is discharged to the receiving environment (sea, river, lake, ground, etc.).

9. TERTIARY TREATMENT - FILTRATION: Sand filtration removes much of the residual suspended matter. - NUTRIENT REMOVAL: Wastewater may contain high levels of the nutrients nitrogen and phosphorus. In certain ways that can be toxic to fish. - DISINFECTION: The purpose of disinfection in the treatment of waste water is to substantially reduce the number of microorganisms in the water to be discharged back into the environment. The effectiveness of disinfection depends on the quality of the water being treated (cloudiness, pH, etc.),