This document provides instructions for section identification and 3D frame creation in the SAP 2000 software. It explains that the section unit can be identified when creating a new model. The document also describes how to select a 3D frame by right clicking on the screen and choosing "Edit grid data". Additionally, it notes that sections can be defined for the model. The presentation was composed by an assistant professor to provide guidance on using SAP 2000.

1. Section Identify and 3D frame creation
in SAP 2000
Composed by
H.M.A. Mahzuz
Assistant Professor (PhD Fellow),
Department of Civil and Environmental
Engineering,
Shahjalal University of Science & Technology
Sylhet,
Bangladesh.
Presentation on

2. Used to create any
new model
Unit can be
identified here

3. Used to select 3D frame

4. Use to
select the
plan

5. Right click on the screen
then click on “Edit grid data”

6. Used to Define
sections

22. X-15’ Y-30’

30. Thank you