The document provides installation instructions for the Ademco 5814 Door/Window Transmitter wireless security device. The transmitter uses a reed switch and magnet to detect the opening and closing of doors and windows. It communicates with compatible alarm systems and must be programmed with its unique serial number. The transmitter should be mounted with double-sided tape and a magnet positioned near the alignment mark to indicate opening and closing. It is assigned to a single zone and must be treated as a supervised RF device during programming.

1. N8788V1 5/99 Rev. B BATTERY
PC BOARD COVER PRY
(+SIDE UP)
ADEMCO 5814 OFF POINT
1/2” MAX
DOOR/WINDOW « SPACING
TRANSMITTER
REED SWITCH
INSTALLATION INSTRUCTIONS ON UNDERSIDE
OF PC BOARD MAGNET
Use the 5814 Door/Window Transmitter only with (IN UNIT)
alarm systems that support 5800 series wireless
devices. The transmitter has its own unique serial
GUIDE MARK
number permanently assigned during manufacture, 5814 WITH BACK q SYMBOL ON SIDE OF FOR MAGNET
CASE SHOWS
COVER OFF LOCATION OF REED SWITCH
which must be entered into the control panel prior to
the transmitterÕs usage. Refer to the control unit's FCC STATEMENT
installation instructions for programming details. FCC ID: ÊCFS8DL5814
Note: During programming of the control unit, 5814 This device complies with Part 15 of the FCC Rules.
transmitters should be treated as "RF" (i.e. supervised Operation is subject to the following conditions:ÊÊ(1) This
device may not cause harmful interference, and (2) must
RF) Type (mandatory for UL installations ). The 5814 is accept any interference received, including interference that
assigned one zone. may cause undesired operation.
MOUNTING SPECIFICATIONS
The unit is generally mounted as shown in the
diagram, with the magnet located to the unit's right. Unit Dimensions:
However, it can be installed in any position, as long as 1-1/2Ó (37mm) x 1-3/16Ó (30mm) x 5/8Ó (15mm)
the relationship of the unit to the magnet is Battery: Duracell DL2430 or Renata/Sanyo/Varta
maintained. CR2430
Before mounting the transmitter permanently, conduct
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE
Go/No Go tests (see control's instructions) to verify RECEIVER/CONTROL WITH WHICH THIS DEVICE IS
adequate signal strength from the mounting location. USED FOR WARRANTY INFORMATION, AND DETAILS
REGARDING THE LIMITATIONS OF THE ENTIRE ALARM
1. Mount using double -faced tape (supplied) by SYSTEM.
affixing it to the back of the unit and mounting the
unit in place.
Warning: Do not mount unit in a location 165 Eileen Way, Syosset, New York 11791
Copyright © 2004 Honeywell International Inc.
where temperature my approach freezing point
(32°F). www.honeywell.com/security
2. Mount the magnet (supplied) adjacent to the
alignment mark on the unitÕs case (see Diagram).
àN8788V1Üä
N 8788V 1 5/99 R ev. B