The document describes the process taken to create a custom font for a film title. First, an existing font called "Urban Jungle" was used as a template to edit into a new font. Blood splatter effects were then added on top of the font letters and unnecessary splatter outside the letters was deleted. Finally, a metal texture was added underneath the blood splatter to complete the custom font with the desired look and elements.

1. From attempting various fonts I realised that none of them had the
specific detail I wanted. Therefore, I decided to create my own
font that would have the elements I wanted. I found the ‘Urban
Jungle’ font most appealing for my genre so I will firstly use this as
a basic template for me to edit it to make it my own.

2. So to start, I made the entire font black removing the broken pieces
inside as seen before.

3. Next I had to add the the blood splatter effect so I found
a royalty free Pre-Keyed Blood Splatter effects online which would
create this blood splatter.

4. I then had to add this onto the font, to do this I simply had the blood
splatter layered on top of the font. I then highlighted the font and
simply deleted the unnecessary blood splatter that wasn't touching
the font.

5. This is what the blood splatter looked like after adding it onto the font.

6. I then done the same technique with the blood splatter to all the
other letters to gain this outcome.

7. After, I realised that the blood splatter wasn't as visible as I wanted it
to be, so I changed the colour balance by increasing the colour levels
for red much higher to make it standout more.

8. I went on to add this metal textured look behind the blood splatter
because I felt that the black was too basic.

9. I added this by layering just under the blood splatter so it will be
visual under it. I then highlighted the font and simply deleted the
texture outside of the font.

10. This is the final completed film Title.