This presentation comes from the Building Commissioning process. It gives attention to the training requirements and defines the training sessions of the syllabus.

1. BUILDING SYSTEMS TRAINING
SYLLABUSSYLLABUS
N. A. CHAZAPIS
Commissioning Consultant

2. Building Systems Training Syllabus

3. Building Systems Training Syllabus
• ELECTRICAL SYSTEMS
• 1st Session (start-up and check-out)
– Switchboards
– Emergency power supply system– Emergency power supply system
– Medium voltage switchgear
– Lighting control systems
– Fire Alarm Systems
– CO detection and exhaust systems

4. Building Systems Training Syllabus
• ELECTRICAL SYSTEMS
• 2ND Session (two months later)
– Operating procedures of the entire electrical
installationinstallation
– Routine maintenance procedures
– Specific O&M procedures provided by Factory
trained technicians.

5. Building Systems Training Syllabus
• MECHANICAL SYSTEMS
• 1st Session (at start-up and check-out).
– Pumps and Inverters
– Chillers
– C.T– C.T
– Boilers and DHW
– Fans and Inverters
– Air handing Units
– Fan coil Units
– Plumping
– Fire protection pumps

6. Building Systems Training Syllabus
• MECHANICAL SYSTEMS
• 2ND Session (two months later)
– Operating and maintenance procedures
– Routine maintenance procedures– Routine maintenance procedures
– Automatic temperature control systems
– Clean agent fire suppression systems

7. Building Systems Training Syllabus
• DDC CONTROLS
• 1ST TRAINING SESSION (16 hours)
– DDC Systems operation basics.
• 2ND TRAINING SESSION (32 hours)• 2ND TRAINING SESSION (32 hours)
– DDC Systems emphasis on advanced features.
– Energy conservation strategies.
– Troubleshooting.
– Fault detection and diagnostics.