Gfe Mayur Vihar Call Girls Service WhatsApp -> 9999965857 Available 24x7 ^ De...
T hin client configuration
1. PUNDIT GLOBAL SERVICE LIMITED
Opposite ECO-Bank, Plc
Niger/State
Bida
First Step : System Configuration And Settings
Make sure your operating system is in good order and virus are not on the operating system
Check system configuration and the bit of the operating system
The ram ,the hard disk size and the bit of operating system . 32bit or 64bit
2. Then turn of window farewell, both public and private network
Navigate and right click on the network icon and open network and sharing center
Click change adapter settings
Right click on local area network connection
Click status or properties
3. Click details
Check the ipv4 address 192.168…………
Observe the gateway ipv4 192.168.1.1
Ipv4 DNS Sever must correspond with gateway address
Click close
Second Step :Network Connections And Ip Generation
4. Right click on the local area network
Click properties
Double Click ipv4 internet protocol
Click on use following ip address
Enter the ip of your choice
E-g 192.168.1.160,sub mark ..255.255.255.0,Default Gateway..192.168.1.1 DNS
Server 192.168.1.1
Click close
Click ok
Close the the Pop Up
Third Step :Creation Of Sub-Client Account
Create users
5. Right click on computer
Navigate and click manage
Click local users and group
Click user
From the user environment right click and select new user
Enter username e-g user 1
Enter password of your choice
Unclick the active cell and select password never expires cell
Click create
Close the page
6. Step Four : Remote DesktopConnection
Right click on computer
Click property
Click remote setting
Allow connection from computer running remote desktop connection (less secure)
Click on Select user
Click add
Click advance
Click find now to add all the created accounts
Scroll down to locate the created users
Click and add it up
Click ok and ok
7. Step Five: Remote Security Change Settings
Click window R’ on keyboard
Type in gpedit.msc
Click ok
Click administrative template
Click window component
Scroll down and click remote desktop service
Click remote desktop session host
Click security
Click require user authentication for remote connection by using ………….
Click disable
Click ok
Click require use for specific security layer for remote (RDP)
Click enable
Click ok
8. Close the page
Turn off antivirus software
Finally Software Installation And Patch Process
Insert installation client CD
Open client CD
Open EN
9. Open win CE
Open software multi user
Open IPC
Select Os install on server e.g win 7
Click win 7 registration entries
Click yes
Click ok
Scroll down and click win 7 mu
Click patch
Click ok
Click no
Click close
10. That is the end
Therefore, installer should move to the client configuration by setting the date and
time and further to create a username as created on the server .
Enter valid IP address which will not create a conflict with another system and click
save and turn off the tin client and turn on again and connect .
Thank you