RECTANGLE

1. Rectangle
With this command, you
can specify the rectangle
parameters
(length, width, rotation) and
control the type of corners
(fillet, chamfer, or square).

2. Rectangle
(Pull-down Menu)
Draw Rectangle
(Tool bar Icon)
(Typed-Command) Rec (Enter)

3. Other Corner Point
Creates a rectangle using
the specified points as
diagonally opposite corners.
2
1

4. Area (A)
Creates a rectangle using
the area and either a length
or a width.
W
L

5. Dimension (D)
Creates a rectangle using
length and width values.
Specifying its length and
width accordingly.
20
30

6. Rotation (R)
Creates a rectangle at a
specified rotation angle.
Specify rotation angle or
(Points) Specify an angle by
entering a value.

7. Chamfer
-is used to create slanted
edges. We are required to
select the two adjacent lines to
create chamfer between them.
7

8. Fillet
-allows you to create fillets on
an edge. Fillets are rounded
edges that are used for cosmetic
purposes, such as rounding the
sharp corners of a door or
window frame.
8