Dennis K. Lamary has over 15 years of experience in machining, maintenance, and installation work. He has worked as a CNC machine operator, cable installer, and handyman. Most recently, he worked as a machinist at BMW Precision Machining, where he operated mills, changed tools, inspected parts, and kept work areas clean. He graduated from the Mira Costa Machining Technology Program in 2013.
1. Dennis K. Lamary
760-445-4126
Work experience:
For Tristaff at BMW Precision Machining Inc. Oceanside, CA. 11/4/14-5/29/15
Tel. 760-439-6813; Supervisor-Rommel, worked on 1-2 Kit mills, 1st
shift
● Daily filled machines with coolant & various oils
● Changed tools when worn or broken, made minor adjustments
● Touched off new tools, reset work offsets
● Cleaned mills inside & out, kept work area clean
● Checked parts with mics, calipers and visual
● Filled out daily paperwork as required
For Aerotek & The Eastridge Group at Veridiam Oceanside, CA. 07/2013-07/2014
CNC machine operator
Ran parts on CNC mills, Swiss and lathes
Measured part features, according to blueprints, using: micrometers, calipers, comparators, tool
makers, visual and deburred when needed.
Replaced broken/worn tools when needed and adjusted work offsets on machine
Kept work area clean/organized, kept parts in appropriate trays.
Sunshine Communications Inc. Oceanside, CA 03/2007-6/2012
Cable Installer/troubleshooter
A Residential video, whole home DVR, internet, wireless routers and phone.
Pre-called customers prior to arrival and gave an approximate arrival time, reviewing customer’s
services and possible problems with equipment before meeting customer.
Listened to customer explain problems they have been experiencing, investigated problems at modem,
TV, cable box and/or house wiring.
Checking cable, signal, fittings, splitters and wall plates, toning out the line back to smart panel or pre-
wire.
Replaced when necessary any old/bad cable, phone wire, fittings, splitters, drops, wall plates and
grounding issues.
Dennis’ Handyman Service Oceanside, CA 06/2005-02/2007
Handyman/painter
●
Mountain Water Ice Co. Oceanside CA 03/2003-06/2005
Maintenance
Monitored ice making machines and storage bins, rebuilding water pumps, rebuilt/repaired staple
machines.
Performed preventive maintenance on tractor trailer refrigeration units- changing oil, oil filter, belts,
coolant, checking battery and fuel filter.
Performed PM work on motorized pallet jacks and forklifts-greasing all points, checking batteries,
cleaning corrosion and replacing worn out battery cables.
Education:
Graduated from Mira Costa Machining Technology Program on 6/7/2013
Trained in: blueprint reading and understanding, manual mill and lathe operations-facing, turning,
threading, parting and tapering. CNC work and tool offset manual and probe, OSHA 10, basic geometry
and trigonometry, micrometers, vernier calipers, dial indicators, drilling, threading, tapping, reaming
and polishing.