The document discusses different types of axles used in vehicles. It describes front axles which support the front of the vehicle and facilitate steering. Front axles can be dead axles, which do not rotate, or live axles which transmit power to the front wheels. Rear axles support the weight of the vehicle and transmit driving thrust. The document outlines full-floating, semi-floating, and three-quarter floating rear axles and how they differ in how they carry weight and transmit torque. It also discusses stub axles which connect to the front axle and allow the front wheels to turn for steering.
Study on Air-Water & Water-Water Heat Exchange in a Finned Tube Exchanger
Understanding Front and Rear Vehicle Axles
1.
2. An axle is a central shaft for a rotating wheel or gear.
On wheeled vehicles, the axle may be fixed to the wheels,
rotating with them, or fixed to the vehicle, with the wheels
rotating around the axle.
Bearings or bushings are provided at the mounting points
where the axle is supported.
3.
4. Front wheels of the vehicle are mounted on front axles .
It supports the weight of front part of the vehicle.
It facilitates steering.
It absorbs shocks which are transmitted due to road
surface irregularities.
It absorbs torque applied on it due to braking of vehicle.
5.
6. Dead axles are those axles,
which do not rotate.
These axles have sufficient
rigidity and strength to take
the weight.
The ends of front axle are
suitably designed to
accommodate stub axles.
7. Live axles are used to
transmit power from gear
box to front wheels.
Live front axles although,
resemble rear axles but they
are different at the ends
where wheels are mounted.
Maruti-800 has line front
axle.
8. Rear wheels of the vehicle are mounted on rear axles .
FORCES ON REAR AXLE
Weight of the body
Driving Thrust
Torque reaction
Side Thrust
11. The weight of the axle is supported by the axle
housing-more specifically, a bearing spindle
attached to the axle housing, and a set of bearings
in a separate wheel hub.
Torque is transmitted by a separate axle shaft that
carries no weight.
As commonly built, full-floaters are considerably
heavier, but also much stronger.
12.
13. With a semi floating axle, the axle shaft both
carries the weight and transmits torque.
The wheel is often bolted directly to the flange on
the axle.
Semi float axles are seen on cars and light duty
trucks.
Semi floats are more limited in capacity, but
lighter and cheaper to manufacture.
14.
15. This type of axle is a combination of full and semi floating bearing.
In this bearing is locating between the axle casing and hub axle shaft
do not have to withstand any shearing or bending action due to the
weight of the vehicle, which are taken up by the axle casing through
hub and bearing.
However it has to take the end loads and driving torque.
A three quarter floating axle is same as semi floating with one
difference. The outer bearing is moved to the outside of the outer
end of the axle tube, supporting hub assembly via the bearing’s
outer circumference edge.
16. Stub axles are connected to the front axle by king pins.
Front wheels are mounted on stub axles arrangement for steering.
Stub axle turns on king pins.
King pins is fitted in the front axle beam eye and is located and locked
there by a taper cotter pin.
Stub axles are of four types:
1. Elliot
2. Reversed Elliot
3. Lamoine
4. Reversed Lamoine