2. Production of the Inlay
The first process was to cut out
the image I wanted to use as I
only wanted the imagine of the
female and male actors
hugging.
3. Production of the Inlay
Once I got the correct
dimension for the Inlay, I then
matched the colour of the
album cover to ensure both are
the same colour.
4. Production of the Inlay
I then used the image I cut out
at the first stage of the
production and dragged it onto
the base of the inlay.
5. Production of the Inlay
I then flipped the image so
instead of the picture being on
the right hand side, it was
based on the left, however,
with the artist still looking
inwards.
I did this by stretching the
picture of itself.
6. Production of the Inlay
I then added the writing and
made sure it fit the album
cover and picture.
I underlined the word ‘hold’
because the female artist is
holding on to the male.
I also wrote the word ‘tear’ in
the trash font to link in with the
album name.
7. Production of the Inlay
At the bottom I simply wrote a
credit in the same font as the
message but in a smaller font.
