How to Control Needle II Needle Controlling Procedure in Apparel Industry II RMG II Garments

1. ©taraquetex_dhk
Needle Control Policy
Needle Control
This section provides procedures for a variety of situations involving sewing needles.
Sewing Needle Control
This needle control policy covers the strict control of all needles to ensure that the only
ones in use are for the manufacturing process and that the disposal of all worn or broken
needles is carried out by authorized personnel.
• The only needles allowed at work stations are those currently needed to operate the
machine process. No spare needles should be held at machine point.
• New needles are kept in a locked location only to be accessed by trained, authorized
personnel.
Worn needle replacement
• Needles which are worn or damaged but not broken are to be collected and a new
needle must be issued by the authorized personnel.
• Old needles are to be disposed of into a sealed jar or tin with a small opening in
the top. The jar must be kept in the secure location and disposed of responsibly.
For manual and automated knitting machine needles, sealed disposal containers
can be placed near the machines.
• The number of worn or damaged needles should be counted and used to update the
needle audit report.
Broken needles
• When a needle breaks, the operation must be stopped and the supervisor informed.
• All the needle pieces must be located and checked against a whole needle to make
sure all the pieces have been found.
• The pieces must be immediately attached to the record sheet with clear adhesive
tape and fully recorded with all information (see Section F).
• A new needle may only be issued when it is confirmed that all the needle pieces are
found.

2. ©taraquetex_dhk
• If all needle pieces cannot be found then the product being worked on and any other
work in close proximity must be placed into a bag or box and taken to the isolation
area for further checking.
• The workplace must be checked with a hand-held metal detector or magnet before
work restarts. The hand- held detector must be calibrated and operating correctly,
using the 1.2mm test piece before being used.
• Check for the missing needle pieces in the isolation area. If found, all the pieces are
to be recorded on the record sheet as normal. If not found, the products must be
placed in a polythene bag and deposited in the secure reject box ready for disposal
later.
• When the workplace is confirmed as clear, then a new needle can be issued – the
policy must be ‘one needle
out, one needle in.’
• Record sheets should be kept for a minimum of one year.