Lab 3 for the Microprocessors Laboratory course involves two experiments worth 10 points each: 1. Students will demonstrate that their Pt-51 microcontroller kit is functioning properly by running a test code that checks the peripherals. They will load a test file to see LEDs toggle on the board and inform the TA of any failed tests during a viva session. 2. Students will write code to read and write values from Port 1 on the microcontroller. Based on the lower nibble of P1, they will toggle four port pins at different intervals - with the highest pin toggling the slowest and the lowest pin toggling the fastest. Students must verify the toggling periods using a logic analyzer in Keil