Configure the topology as shown above Configure devices using the topology table Configure a routing protocol Part 2: Configure SNMP Manager & Agents PC-A Configure the SNMP Manager (MIB Browser) Configure an SNMP agent on R1 Part 3: Gathering Information Open the MIB browser on PC-A Set the Address to that of R1 Click Advanced enter in your Community values Change SNMP Version to v2 In the SNMP Router_std MIBs Section navigate to: .iso .org .dod .internet .mgnt .mib-2 .system Change the Operations to Get Bulk and click Go. ANSWER THIS: What do you see? ANSWER THIS: Can you gather any other information from the Router? If so, what? Part 4: Syslog Place a Server off Fa0/9 on S1 Give the Server an IP Address of 192.168.1.10 On R1 and R2 enable logging to the Server On the Server view the Syslog service ANSWER THIS: What type of events are you able to have shown? You must provide at least 3 events. Topology:.