Cleaning and maintenance pebble card printer

1. www.euccoi.com
Cleaning and maintenance
Cleaning and maintenance of Card Printers:
1. purity 99% anhydrous alcohol soaked cleaning card
2. 99% purity alcohol-soaked cotton swabs
3. Cleaning cloth
Cleaning and maintenance cycle: Each time you put 1000 cards
Tool: Cleaning Card When the cleaning and maintenance period expires, the printer's yellow cleaning lamp will light up. If the printer is
not cleaned and maintained and 200 additional cards are accumulated, the yellow cleaning lamp will flash. At this time, must be clean,
without delay! (Maximum can not put 5 more cards). Otherwise, printhead warranty terms are canceled, which means that will refuse to
provide you with a one-year printhead warranty service.
1. clean the printer interior:
First you need to prepare a cleaning card.
Through repeated movements of the cleaning card inside the card printer, the card transport wheel, the cleaning wheel, the print head
and the like are cleaned.
1 Remove the card feeder
2. Remove the card from the card feeder
3. Remove the cleaning card, into the card feeder
4 Confirm card thickness adjustment to Max position

2. www.euccoi.com
5 Reset card feeder
6. Remove the ribbon from the printer
7. Close the printer cover
8. Press the control panel button and hold for 1 second, cleaning starts.
9. After cleaning, the cleaning card is spit out from the card exit.
2 minutes after cleaning is complete, wait for the detergent to evaporate completely, re-install the ribbon, and start printing.
You do not have to wait for the yellow cleaning light prompts to do cleaning and maintenance. Frequent cleaning and maintenance for
the printer's performance is undoubtedly a considerable help!
2. print head maintenance
Open the printer cover, wipe the print head with a dry alcohol swab.
2 minutes after cleaning is complete, wait for the detergent to evaporate completely, re-install the ribbon, and start printing.
3. clean wheel cleaning
Open the printer cover, remove the cleaning wheel, and use a cleaning cloth to remove dust from the surface of the cleaning wheel.
2 minutes after cleaning is complete, wait for the detergent to evaporate completely, re-install the ribbon, and start printing.